SBI-7127R-S6 Blade Module User’s Manual
Jumpers
The jumpers present on the mainboard are used by the manufacturer only; there are no jumpers used to configure the operation of the mainboard.
CMOS Clear
JBT1 is used to clear CMOS and will also clear any passwords. JBT1 consists of two contact pads located near the BIOS chip.
Clearing CMOS
1.First power down the blade and remove it from the enclosure.
2.Remove the blade cover to access the mainboard (see "Removing/Replacing the Blade Cover" on page
3.Replace the cover, install the blade back into the enclosure and power it on.