StorCase Technology DE100i-A100 manual Unit ID Select Switch Location

Installation 11

WARNING: Unlocking the carrier unit switches DC power off to the drive. Since disk drives require a short amount of time to spin down, allow about 15 seconds before pulling the carrier unit out of the receiving frame to avoid possible damage to the drive.

3.Use the alignment tool supplied with the DE100i-A100 to select the ID number of the disk drive. Refer to Figure 10 for the location of the ID Select Switch inside the receiving frame. Table 2 lists the valid unit ID numbers available for the drive.

4.After you have selected an appropriate unit number, replace the DE100i-A100 carrier in the receiving frame, and LOCK IT IN PLACE.

NOTE: The lock on the DE100i-A100 receiving frame functions as a lock and a DC power switch for the carrier unit. The lock must be engaged in order to supply power to the carrier and installed drive.

5.Reboot the computer. The new disk is now ready for use, although it may have to be formatted or initialized prior to use with your operating system and applications software.

	Unit ID
	Number
	Display
Unit ID Select	Lock
	and DC
Rotating Switch
	Power
	Switch
	Front of Unit

Drive Carrier

Guide

Receiving

Frame

0087

Drive Carrier (removed)

Figure 10: Unit ID Select Switch Location

DE100i-A100 User's Guide - Rev. C02 StorCase Technology, Inc.