StorCase Technology DE100i-A100 manual Receiving Frame Rear Panel

Introduction 5

Figure 4: Receiving Frame Unit ID Number and Activity Display

Receiving Frame Rear Panel

(Figure 5)

•DC Power Connector (J3): The DE100i-A100 uses a standard 4-pin DC Power Connector to accept DC power.

•I/O Connector (J2): The input/output connector provides a standard interface for all IDE signals. See Table 3 on page 13 for J2 pin assignments.

•Master/Slave Selection Jumper (J5): Master Drive configuration (default). Forces master drive configuration on receiving frame. Change jumper to set slave drive configuration. Refer to Table 1 on page 12 for further information.

•Device Spin Down/Up Timer Jumper (J6): Jumper installed (Factory Default) enables device spin down/up visual indicator. Receiving frame unit ID number display (Figure 4) will flash to indicate device spin down/up.

DE100i-A100 User's Guide - Rev. C02 StorCase Technology, Inc.