SMC Networks SMCGS24 manual Compliances

Page 9

COMPLIANCES

Please read the following safety information carefully before installing the Switch:

WARNING: Installation and removal of the unit must be carried out by qualified personnel only.

•This guide is intended for use by network administrators who are responsible for setting up and installing network equipment; consequently it assumes a basic working knowledge of LANs (Local Area Networks).

•The unit must be connected to an earthed (grounded) outlet to comply with international safety standards.

•Do not connect the unit to an A.C. outlet (power supply) without an earth (ground) connection.

•The appliance coupler (the connector to the unit and not the wall plug) must have a configuration for mating with an EN 60320/IEC 320 appliance inlet.

•The socket outlet must be near to the unit and easily accessible. You can only remove power from the unit by disconnecting the power cord from the outlet.

•This unit operates under SELV (Safety Extra Low Voltage) conditions according to IEC 60950. The conditions are only maintained if the equipment to which it is connected also operates under SELV conditions.

v

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Page Page EZ Switch 10/100/1000 User Guide Trademarks Limited Warranty Limited Warranty Compliances FCC Class aEC Conformance Declaration Class a Japan Vcci Class a Industry Canada Class aCompliances Power Cord Set Vii Viii Halten Environmental Statement PurposeAudience Warnhinweis Faseroptikanschlüsse Optische Sicherheit Safety ComplianceXii Table of Contents Viii Introduction Features and BenefitsFront Panel LEDs Front Panel RJ-45 PortsRear Panel Installing the Switch Package ContentsSelecting a Site Instructions Installing the Switch Typical application for the SMCGS16 is illustrated below Application ExampleDiagnosing Switch Indicators TroubleshootingSymptom Possible SolutionsCable Specifications Cables10BASE-T/100BASE-TX Pin Assignments 1000BASE-T Pin Assignments Pin MDI-X Signal Name MDI Signal NameCable Testing for Existing Category 5 Cable Adjusting Existing Category 5 Cabling1000BASE-T Cable Requirements EZ Switch 10/100/1000 Product SpecificationsPower Consumption WeightPower Requirement TemperatureProduct Specifications Page For Technical SUPPORT, Call
Top Page Image Contents