ENGLISH |
| ENGLISH |
UP4 RECEIVER SET UP
Attaching The UP4 Receiver Antennas
FIGURE 20
1.Center the antenna over the SMA Antenna Input Connectors on the front panel of the receiver.
2.Rotate the antenna in a clockwise direction until the base of the antenna is threaded firmly to the connector.
Attaching the Mounting Box to a Camera
A
FIGURE 21
1.Locate the battery pack (A) on the camera. If it is a Sony or Anton Bauer equipped camera, there will be four mounting screws on the surface of the battery pack, either on the side or back of the battery pack.
2.Attach the mounting box by inserting the mounting screws in the large ends of the four mounting holes on the box. Lock the box to the battery pack by moving the box down so that the screws are in the small ends of the mounting holes.
3.Tighten the screws by inserting a screw driver into the access holes on the outside surface of the mounting box.
Attaching a Second Mounting Box
FIGURE 22
In some applications, it may be desirable to have two active receivers attached to the camera. In these cases, a second receiver can be “stacked” on the first receiver. To attach a second mounting box to a camera, follow these steps:
1.Insert supplied screws into the four screw holes of the mounted box. Engage the screw, but do not tighten; leave a space between the head of the screw and the surface of the mounting box.
2.Following steps 2 and 3 of Attaching a Mounting Box, using the mounting screws on the outside of the first box instead of the mounting screws on the battery pack.
3.Install the receiver as directed in Installing the UP4 Receiver.
– 10 –