INSTALLING NETWORK DRIVERS
2.Turn your computer on and boot it to the NetWare 4.11 console prompt.
3.At the NetWare console prompt Enter the command “load install” to start the install utility. The Installation Options dialog box is displayed.
4.Select the “Driver Options” menu item and press enter. The “Driver Options” dialog box is displayed.
5.Select the “Configure Network Drivers” menu item and press Enter. The “Additional Driver Actions” dialog box is displayed.
6.Insert the SMC SuperDisk driver diskette into the “A” drive.
7.Select the “Load an additional driver” menu item option and press Enter. The “Select a driver” dialog box is displayed. Press the “Ins” key to install an unlisted driver. A dialog box is displayed indicating that the A drive will be scanned for drivers. Press Enter to continue.
8.Press Enter to select the SMC9462.LAN from the “Select a driver to install” dialog box. A message asking if you want to copy the driver is displayed. Select “Yes” to continue. The device driver is copied.
9.A screen with three dialog boxes is displayed. To change the driver configuration, tab to the “SMC9462_1 Parameters” dialog box and modify the driver parameters. Depending on the network that the card is attached to, the Link, Speed, Duplex Mode, and Phy Type parameters might need to be changed from their default values. If you are not sure what values are required for your network, contact your network administrator.
10.Tab to the “SMC9462_1 Protocols” and select the desired protocols.