Using the Windows-based Utility | SMC Networks SMC2670W specs

Using the Windows-based Utility:

a)Launch the SMC2670W Wireless Adapter Utility b)Log into the SMC2670W

c)Click on the [Setup >] button to access the configuration section. From this section you can configure:

•IP Address

•Subnet Mask

•Gateway

If you encounter problems, power the SMC2670W off and on again, or Reset the unit. Then log back into the web-based or windows-based utility and try to change the IP configuration again.

3.My PC won’t communicate with a PC or printer connected to the EZ Connect Wireless Ethernet Adapter.

Perform the following steps:

a)Verify if the PC or printer connected to the Wireless Ethernet Adapter is on the same wireless network by checking the IP configuration.

b)Verify if the SSID and operating mode are the same for all devices connected to the same wireless network.

c)If the wireless LAN settings are correct, verify all the devices are on the same IP network.

Check the Ethernet crossover cable and make sure it is properly connected and that the LAN LED is lit. If the LED is not lit, confirm you are using a crossover ethernet cable.

4. The Web-Based Utility won’t open.

Make sure that you have a network adapter installed on the PC so you can use the Web-Based Utility. Verify if you can ping the SMC2670W at 192.168.2.25.