SMC Networks Official Manual for SMC EX250 Series Switches and Ethernet/IP Compatibility

Page 1

Reduced wiring system

EtherNet/IP™ Compatible SI Unit

Instruction Manual

EX250-SEN1

URL http:// www.smcworld.com

Specifications are subject to change without prior notice and any obligation on the part of the manufacturer. EtherNet/IP™ is a trademark used under licence by ODVA.

Image 1

Contents Reduced wiring system Contents Otherwise injury or failure can result Do not operate beyond specification rangeOtherwise accident caused by malfunction can result Otherwise injury can resultSystem configuration general SafetyProduct Summary Mounting/Installation Dimensions unit mmSI Unit Model Indication Method Part NamesLayout of the EX9 series Output Block / Power Block Mounting/InstallationLayout of the Input Block Position of End PlateBasic specifications SpecificationsHigher-level bus MappingCommunication wiring WiringPower supply wiring Cable connectionWiring Display/SettingConnecting one or two power supplies to SI Unit Settings for displaySwitch setting Display/SettingDefault settings Input Block Model Indication Method EX250-IE1 EX250-IE2 EX250-IE3 Tie-rod 2 pcs AccessoryInput Block Model indication method Block typeInput connector pin layout Input wiring Cable wiringEX250-IE1 M12 connector, 5 pin, Socket EX250-IE1/2/3Display Power BlockOutput Block EX250-IE1 EX250-IE2/IE3Output Block Power Block Part Names Dimensions unit mmTie-rod 2 pcs Waterproof cap Accessory For socket1 pc Output wiring Cable wiring SpecificationOutput connector pin layout Pin alignment and connection drawing of the Output CablePower Cable Power Block Power supply wiring Power BlockEX9-PE1 pin layout Option DisplayOption TroubleshootingOverall system Check the wiring and pin number TroubleshootingEtherNet/IP compatible communication Green flashing Check the data rate and address