Seagate Medalist 17242 manual FCC verification

Page 23

Medalist 17242, 13032, 10232, 8422 and 4312, Rev. A

15

1.12.3 FCC verification

These drives are intended to be contained solely within a personal computer or similar enclosure (not attached as an external device). As such, each drive is considered to be a subassembly even when it is individually marketed to the customer. As a subassembly, no Federal Communications Commission verification or certification of the device is required.

Seagate Technology, Inc. has tested this device in enclosures as de- scribed above to ensure that the total assembly (enclosure, disc drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception.

Radio and Television Interference. This equipment generates and uses radio frequency energy and if not installed and used in strict accordance with the manufacturer’s instructions, may cause interfer- ence to radio and television reception.

This equipment is designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television, which can be determined by turning the equipment on and off, you are encouraged to try one or more of the following corrective measures:

•Reorient the receiving antenna.

•Move the device to one side or the other of the radio or TV.

•Move the device farther away from the radio or TV.

•Plug the computer into a different outlet so that the receiver and computer are on different branch outlets.

If necessary, you should consult your dealer or an experienced radio/ television technician for additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commis- sion: How to Identify and Resolve Radio-Television Interference Prob- lems. This booklet is available from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC 20402. Refer to pub- lication number 004-000-00345-4.

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Product Manual Page Product Manual Page Contents ATA interface Figures Viii Medalist 17242, 13032, 10232, 8422 and 4312, Rev. a Introduction Specification summary table ST317242A ST313032A Relative humidity Gradient Formatted capacity Default logical geometryDrive Guaranteed Mbytes Bytes per Model LBA ModeDrive Model Read/Write heads MR Number of discs Supported CHS translation geometriesPhysical organization Recording and interface technologyST317242A, ST313032A Physical characteristicsDrive Specification ST310232A, ST38422A ST34312A Seek timeRead Write Seek type Msec, typ Power specificationsPower consumption Start/stop timesTypical current profile Mode Typical Watts RMS Typical Amps RMS 12VVoltage tolerance Power-management modesMode Heads Spindle Buffer Conducted noiseHumidity 3.1 Relative Humidity Environmental tolerances Ambient temperatureTemperature gradient 3.2 Wet bulb temperatureNonoperating shock AltitudeShock Operating shockElectromagnetic susceptibility Typical sound Maximum sound Mode Power belsNonoperating vibration Drive acousticsAustralian C-Tick Agency certification Safety certificationReliability Electromagnetic CompatibilityFCC verification Medalist 17242, 13032, 10232, 8422 and 4312, Rev. a Jumper settings Master/slave configuration Handling and static-discharge precautionsUltra ATA/66 cable Alternate capacity jumperDrive mounting Alternate capacity and master/slave jumper settingsMounting dimensions-top, side and end view Medalist 17242, 13032, 10232, 8422 and 4312, Rev. a ATA interface ATA interface signals and connector pinsO pins and supported ATA signals Code ATA Interface commands Supported ATA commandsCommand name Supported by ATA-standard commandsATA-standard power-management commands Word Description Value Identify Drive commandWord Description 60-61 Total number of user-addressable Description if bit is set to Bit Word 0CH Set Features commandVendor-specific Yes 4 S.M.A.R.T. commandsA.R.T. Enable/Disable Attribute Yes Autosave A.R.T. Read Data YesD3H Medalist 17242, 13032, 10232, 8422 and 4312, Rev. a Medalist 17242, 13032, 10232, 8422 and 4312, Rev. a
Top Page Image Contents