Seagate ST9250315AS, ST980313ASG, ST9500325AS manual Identify Device command, Word Description Value

4.3.1Identify Device command

The Identify Device command (command code ECH) transfers information about the drive to the host following power up. The data is organized as a single 512-byte block of data, whose contents are shown in the table on page 27. All reserved bits or words should be set to zero. Parameters listed with an “x” are drive-specific or vary with the state of the drive.

The following commands contain drive-specific features that may not be included in the Serial ATA specifica- tion.

Word	Description	Value
	Configuration information:	0C5AH
0	• Bit 15: 0 = ATA; 1 = ATAPI
	• Bit 7: removable media
	• Bit 6: removable controller
	• Bit 0: reserved
1	Number of logical cylinders	16,383
2	ATA-reserved	0000H
3	Number of logical heads	16
4	Retired	0000H
5	Retired	0000H
6	Number of logical sectors per logical track: 63	003FH
7–9	Retired	0000H
10–19	Serial number: (20 ASCII characters, 0000H = none)	ASCII
20	Retired	0000H
21	Retired	0400H
22	Obsolete	0000H
23–26	Firmware revision (8 ASCII character string, padded with	x.xx
	blanks to end of string)
27–46	Drive model number: (40 ASCII characters, padded with	ST9500325AS
	blanks to end of string)	ST9500325ASG
		ST9400326AS
		ST9320325AS
		ST9320325ASG
		ST9250315AS
		ST9250315ASG
		ST9160301AS
		ST9160314AS
		ST9160314ASG
		ST9120315AS
		ST9120315ASG
		ST980313AS
		ST980313ASG
47	(Bits 7–0) Maximum sectors per interrupt on Read multiple	8010H
	and Write multiple (16)
48	Reserved	0000H
49	Standard Standby timer, IORDY supported and may be dis-	2F00H
	abled
50	ATA-reserved	0000H
51	PIO data-transfer cycle timing mode	0200H
52	Retired	0200H
53	Words 54–58, 64–70 and 88 are valid	0007H

Momentus 5400.6 SATA Product Manual, Rev. E 29