Seagate ST96023A Configuring and mounting the drive, Handling and static discharge precautions

Page 25

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

•Keep the drive in the electrostatic discharge (ESD) bag until you are ready for installation to limit the drive’s exposure to ESD.

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive only by its edges or frame.

•The drive is fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

3.2Jumper settings

3.2.1Master/slave configuration

Use the options jumper block shown in Figure 3 to configure the drive for operation. This jumper block is the 4- pin header adjacent to pins 1 and 2 of the I/O signal pins. For additional information about using the Cable select option, see section 3.2.2.

The “Master or single drive” option is the factory default setting.

Drive is master (or single drive)

Drive is slave

Cable select

Figure 3. Jumper settings

Momentus 7200.1 PATA Product Manual, Rev. C

19

Page 24 Page 26
Image 25
Page 24 Page 26
Contents ST910021A ST980825A ST96023A ST94015A Momentus 7200.1 PataPage Contents Momentus 7200.1 Pata Product Manual, Rev. C List of Figures Momentus 7200.1 Pata Product Manual, Rev. C Momentus 7200.1 Pata disc drive IntroductionMomentus 7200.1 Pata Product Manual, Rev. C Specification summary Drive specificationsSpecifications Drive specification ST910021A ST980825A ST96023A ST94015A+5V ± 5% / -8% startup LBA mode Default logical geometryFormatted capacity Physical organizationTechnology Specification Physical characteristicsRecording and interface technology Time to ready Seek timeTypical seek times msec Read Write Time to ready Typical MaxPower specifications Conducted noise Typical current profileVoltage tolerance Power management modes Power-management modesActive mode Idle modeEnvironmental specifications Operating shock ShockNonoperating shock VibrationElectromagnetic immunity AcousticsDrive level acoustics Electromagnetic immunityMeasurement type Specification Safety certificationReliability Agency certificationAustralian C-Tick N176 Korean RRLFCC verification European Union Restriction of Hazardous Substances RoHS Environmental protection表示该部件（于同类物品程度上）所含的危险和有毒物质超出中国 Momentus 7200.1 Pata Product Manual, Rev. C Handling and static discharge precautions Configuring and mounting the driveJumper settings Master/slave configurationCable-select option Drive mountingConnector signals ATA interface signals and connector pinsConnector Cable Signal Name Contact Conductor Cable Connector Conductor Contact Signal NameSupported commands Supported ATA commandsCommand name Command code in hex ATA-standard commands ATA-standard power-management commands Command name Command code in hexATA-standard security commands Supported commands Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordFeatures register values Set Features commandInternet Seagate Technology support servicesPresales Support Technical SupportData Recovery Services Authorized Service Centers Warranty ServiceData Recovery Services Call Center Toll-free Direct dial Index Page Page Momentus 7200.1 Pata Product Manual, Rev. C Page Seagate Technology LLC
Top Page Image Contents