Seagate ST150176LW/LC manual Electromagnetic compliance for the European Union, Australian C-Tick

Page 11

Barracuda 50 Installation Guide, Rev. A

9

Electromagnetic compliance for the European Union

If this model has the CE Marking it complies with the European Union requirements of the Electromagnetic Compatibility Direc- tive 89/336/EEC of 03 May 1989 as amended by Directive 92/31/ EEC of 28 April 1992 and Directive 93/68/EEC of 22 July 1993.

Australian C-Tick

If this model has the C-Tick Marking it complies with the Austra- lia/New Zealand Standard AS/NZS3548 1995 and meets the Electromagnetic Compatibility (EMC) Framework requirements of Australia’s Spectrum Management Agency (SMA).

Image 11

Contents

Barracuda Disc Drive Contents Preface Electrostatic discharge protection Handling precautionsImportant safety information and precautions Barracuda 50 Installation Guide, Rev. a Wichtige Sicherheitshinweise Barracuda 50 Installation Guide, Rev. a Barracuda 50 Installation Guide, Rev. a Electromagnetic compliance Regulatory agency complianceElectromagnetic susceptibility Australian C-Tick Electromagnetic compliance for the European UnionGeneral description Primary benefits of LVD technology Single-ended and low voltage differential modesProviding adequate cooling SE and LVD bus configurationsData bus widths Kühlung des Systems Suggested air flow Characteristics ST150176LW/LC +12 Set the Scsi ID on the drive ST150176LW installationSetting the Scsi ID on ST150176LW drives Configure termination Scsi bus termination Setting terminator power jumpers Configure termination powerConnect the drive activity remote LED optional Drive Active LED indicator connectionsParity Check option Delay Motor Start and Motor Start optionsWrite Protect option Additional jumper options Format the drive Mount the drive in the host system and connect cablingConnecting cables to the drive Multiple-drive connection to host adapter Mounting configuration dimensions LW model Alternate Scsi ID select and LED connection Additional connector on ST150176LW drivesScsi ID ST150176LC installationSetting the Scsi ID on ST150176LC drives Configure termination Delay Motor Start and Motor Start options Additional jumper options Pin I/O connection to drive LC model Mount the drive in the host systemMounting configuration dimensions LC model Important information about formatting the drive System preparation DOS, Windows 3.1, Windows 95, and WindowsDrive formatting Macintosh Seagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services SeaFAX Page Page