Seagate ST150176LW/LC manual Mounting configuration dimensions LW model

Page 30

28	Barracuda 50 Installation Guide, Rev. A

//

T -Z- S

		K
	[1]	-Z-
H	L
		J
	B

R

A

-Z-

M

U -X-

Notes:

[1]Mounting holes are 6-32 UNC 2B, three on each side and four on the bottom. Max screw penetration into side of drive is 0.15 in. (3.81 mm). Max screw tightening torque is 6.0 in-lb (3.32 nm) with minimum full thread engagement of 0.12 in. (3.05 mm).

P

[1]

G

F

E D

C

Dimension Table

	Inches		Millimeters
A	1.654	max	42.01	max
B	5.787	max	147.00	max
C	4.000	± .010	101.60	± .25
D	3.750	± .010	92.25	± .25
E	.125	± .010	3.18	± .25
F	1.750	± .010	44.45	± .25
G	1.625	± .020	41.28	± .50
H	1.122	± .020	28.50	± .50
J	4.000	± .010	101.60	± .25
K	.250	± .010	6.35	± .25
L	1.638	± .010	41.60	± .25
M	.181	± .020	4.60	± .50
P	1.625	± .020	41.28	± .50
R	.265	± .010	6.73	± .25
S	.315	± .040	7.00	± .10
T	.015	max	0.38	max
U	.015	max	0.38	max

-X-

Figure 10. Mounting configuration dimensions (LW model)

Image 30

Contents

Barracuda Disc Drive Contents Preface Handling precautions Electrostatic discharge protectionImportant safety information and precautions Barracuda 50 Installation Guide, Rev. a Wichtige Sicherheitshinweise Barracuda 50 Installation Guide, Rev. a Barracuda 50 Installation Guide, Rev. a Regulatory agency compliance Electromagnetic susceptibilityElectromagnetic compliance Electromagnetic compliance for the European Union Australian C-TickGeneral description Single-ended and low voltage differential modes Primary benefits of LVD technologySE and LVD bus configurations Data bus widthsProviding adequate cooling Kühlung des Systems Suggested air flow Characteristics ST150176LW/LC +12 ST150176LW installation Set the Scsi ID on the driveSetting the Scsi ID on ST150176LW drives Configure termination Scsi bus termination Configure termination power Setting terminator power jumpersDrive Active LED indicator connections Connect the drive activity remote LED optionalDelay Motor Start and Motor Start options Write Protect optionParity Check option Additional jumper options Mount the drive in the host system and connect cabling Format the driveConnecting cables to the drive Multiple-drive connection to host adapter Mounting configuration dimensions LW model Additional connector on ST150176LW drives Alternate Scsi ID select and LED connectionST150176LC installation Scsi IDSetting the Scsi ID on ST150176LC drives Configure termination Delay Motor Start and Motor Start options Additional jumper options Mount the drive in the host system Pin I/O connection to drive LC modelMounting configuration dimensions LC model Important information about formatting the drive DOS, Windows 3.1, Windows 95, and Windows System preparationDrive formatting Macintosh Seagate Technology support services Presales Support Customer Service CSO European Support Services Africa/Middle East Support Services SeaFAX Page Page