Seagate ST3400632A Configuring and mounting the drive, Handling and static discharge precautions

Page 27

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

Barracuda 7200.8 PATA Product Manual, Rev. F

21

Image 27

Contents Barracuda 7200.8 Pata Page Contents Barracuda 7200.8 Pata Product Manual, Rev. F List of Figures Barracuda 7200.8 Pata Product Manual, Rev. F Barracuda 7200.8 Pata IntroductionBarracuda 7200.8 Pata Product Manual, Rev. F Specification summary table Drive specificationsDrive specification ST3400832A ST3400632A Drive specifications for 400 Gbyte modelsBarracuda 7200.8 Pata Product Manual, Rev. F Drive specification ST3300831A ST3300631A Drive specifications for 300 Gbyte modelsFollowing web Drive specification ST3250823A ST3250623A ST3200826A Drive specifications for 250 and 200 Gbyte modelsBarracuda 7200.8 Pata Product Manual, Rev. F Recording and interface technology Default logical geometryLBA mode Formatted capacityPhysical characteristics Seek timeStart/stop times Power specifications Typical current profile Conducted noiseVoltage tolerance Sleep mode Power-management modesActive mode Idle modeEnvironmental specifications Vibration ShockOperating shock Nonoperating shockRadio frequency environments AcousticsElectromagnetic immunity Fluid Dynamic Bearing FDB motor acousticsElectromagnetic compatibility Safety certificationReliability Agency certificationFCC verification Australian C-Tick N176Environmental protection Corrosive environmentEuropean Union Restriction of Hazardous Substances RoHS Handling and static discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsCable-select option Jumper settingsMaster/slave configuration Drive as master with a non-ATA-compatible slaveUltra ATA/100 cable Drive mountingMounting dimensions-top, side and end view Barracuda 7200.8 Pata Product Manual, Rev. F ATA interface ATA interface signals and connector pinsCommand name Command code in hex Supported ATA commandsF4H Word Description Value Identify Device commandXx07H Description if bit is set to Bit Word 4 S.M.A.R.T. commands Set Features commandCode in features Register A.R.T. command Technical Support Seagate Technology support servicesInternet Presales SupportWarranty Service Data Recovery Services Authorized Service CentersData Recovery Services Call Center Toll-free Direct dial Index Page TMR Barracuda 7200.8 Pata Product Manual, Rev. F Page Seagate Technology LLC