Hawk 1LP Family Installation Guide, Rev. D | 31 |
continued from previous page
SSP* Used only as a cable connection for the refer- ence index signal (REFIND+) (J6 Pin 6, bot- tom) for sync spindle feature. J6 pin 5 is GRD. Install a jumper when no cable is attached. Default is a jumper installed (not applicable to "NC" models).
LED* No jumper ever installed. These pins used to connect a cable for a remote LED indicator. Pin 3 (top, nearest HDA), the anode connection, connects in the drive to the +5V supply through a
RES Reserved position. No jumper to be installed.
* See note [2] on page 27