Seagate ST3620N/ND/NC, ST31200N/ND/NC manual Hawk 1LP family NC models 80 pin Scsi I/O

Page 25

Hawk 1LP Family Installation Guide, Rev. D

23

Hawk 1LP family NC models (80 pin SCSI I/O)

On Model NC drives there is no J5. J6 can be used to set drive ID, but the host probably does it over the 80 pin interface. J6 is used to select other configuration op- tions as has previously been described, or is described in the notes following Figure 3b.

Image 25
Contents ST3620N/ND/NC Contents Electromagnetic interference EMI considerations IntroductionPage Before you begin Page Page Safety instructions Vorsicht SicherheitsanleitungInstallation Overview Page Product repair information Product repair and return information SeaFAX number 408/438-2620 Technical support servicesSeaFONE telephone number 408/438-8222 SeaBOARD serviceSeaTDD telephone number 408/438-5382 Modem Maximum Location Number Baud Rate BBSModel Hawk 1LP Family product informationPage Scsi interface cable connection Initial set-up informationScsi address selection DC Power connectionTerminator resistor packs Read/Write head auto-park Optional parity bit enableWrite precompensation and reduced write current Pin Hawk 1LP family N/ND models 50 pin Scsi I/O Drive configurationHawk 1LP family NC models 80 pin Scsi I/O Drive configurator, Hawk 1LP family N/ND models HDA Scsi I/O Drive configurator for Hawk 1LP family NC drives Hawk 1LP Family Installation Guide, Rev. D RES Hawk 1LP Family Installation Guide, Rev. D TP Position a N family models only Hawk 1LP Family Installation Guide, Rev. D Disc drive mounting Drive installationPage Inches Pin Connector Centerline Mounting holes three on each side Grounding Scsi interface drives Publication Number 77767453, Rev. D