Hawk 1LP Family Installation Guide, Rev. D | 33 |
•Mount to host system chassis using four 6-32 UNC screws. Three mounting holes are in each side and four in the bottom of the drive. See Figure 4. The maximum length that the screws should extend into the side chassis mounting holes is 0.15 inch (3.81 mm), and 0.20 inch (5.1 mm) into bottom holes, measured from the outer surface of the chassis. The minimum thread engagement for all mounting screws is .12 inch (3.0 mm). Tighten the screws evenly to a maximum torque of 8 in-lb (.90 NM). Do not over tighten or force when screw does not seem to screw in easily (threads not correctly engaged).
•Verify that all connections between the drive and the host system are correctly installed. Most cables have a contrasting color stripe indicating pin 1. Pin 1 on the drive I/O connector and the DC power connector are indicated in the figures in the Initial Set-up Informa- tion section.
•Verify option select and drive ID select jumpers and installation of terminator resistor packs where appli- cable. See Drive Configuration section.
