Seagate ST3620N/ND/NC, ST31200N/ND/NC Pin Connector Centerline Mounting holes three on each side

Hawk 1LP Family Installation Guide, Rev. D 35

			[4]
C	[3]	G	L
	[1]	D
	F		E
	A
		Notes:

R

[5]

Pin 1

B

Connector Centerline

J

[2]

H

K

N

[4] M

[1]Mounting holes three on each side,

6-32 UNC. Max screw length into side of drive 0.15 in. (3.81 mm). Maximum torque 8 in-lb (.90 NM). Min. thread engagement 0.12 in. (3.0 mm).

[2]Mounting holes four on bottom, 6-32 UNC. Max screw length into bottom of drive 0.20 in. (5.08 mm). Maximum torque 8 in-lb (.90 NM). Min. thread engagement 0.12 in. (3.0 mm).

[3]Interface connector can extend past the "A" dimension by 0.020 in. (.51 mm).

[4]Decorative front panel.

[5]Connector is centered on drive within ±0.020 in. (.508 mm).

		Inches		Millimeters
	A	5.74	± .010	145.80	± .25
	B	4.00	± .010	101.60	± .25
	C	1.00	± .034	25.40	± .86
	D	2.362	± .010	60.00	± .25
	E	.620	± .010	15.75	± .25
	F	4.000	± .010	101.60	± .25
	G	.250	± .018	6.35	± .46
	H	1.750	± .010	44.45	± .25
	J	3.750	± .010	95.25	± .25
	K	2.370	± .010	60.20	± .25
	L	1.11	± .010	28.19	± .25
P	M	4.100	± .010	104.14	± .25
	N	0.19	± .010	4.83	± .25
	P	0.015	max	0.381	max
	R	0.181	+ .018	4.597 + .45
			– .013		– .33

Figure 5. Hawk 1LP family NC model mounting configuration dimension (80 pin I/O con- nector)