Seagate ST3160318AS, ST31000528AS manual Drive mounting, Mounting dimensions 1000 and 750 GB models

Page 29

3.4Drive mounting

You can mount the drive in any orientation using four screws in the side-mounting holes or four screws in the bottom-mounting holes. See Figure 3 for drive mounting dimensions. Follow these important mounting precau- tions when mounting the drive:

•Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.

•Use only 6-32 UNC mounting screws.

•The screws should be inserted no more than 0.150 inch (3.81 mm) into the bottom or side mounting holes.

•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

Recommended case temperature measurement location

Figure 3. Mounting dimensions (1000 and 750 GB models)

Barracuda 7200.12 Serial ATA Product Manual, Rev. B

23

Image 29

Contents Barracuda 7200.12 Serial ATA Revision Date Sheets affected or comments Revision historyContents Barracuda 7200.12 Serial ATA Product Manual, Rev. B List of Figures Page Introduction About the Serial ATA interface Drive specifications Drive specifications summary for 1000 and 750 Gbyte models Will display the warranty information for your drive Drive specifications summary for 500 Gbyte models Tem will display the warranty information for your drive Drive specifications summary for 250 Gbyte models Will display the warranty information for your drive LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Recording and interface technology Physical characteristicsStart/stop times Seek timeTypical seek times msec Read Write 750 GB models 500, 320, 250 and 160 GB modelsPower specifications Active mode Power-management modesIdle mode Sleep modeEnvironmental specifications Operating shock ShockNonoperating shock 750 GB models 500, 320, 250 and 160 GB modelsElectromagnetic immunity AcousticsFluid Dynamic Bearing FDB motor acoustics Test for Prominent Discrete Tones PDTsReliability Safety certificationAgency certification Electromagnetic compatibilityFCC verification Korean RRLAustralian C-Tick N176 Corrosive environment Environmental protectionHandling and static-discharge precautions Configuring and mounting the driveSerial ATA cables and connectors Configuring the driveDrive mounting Mounting dimensions 1000 and 750 GB modelsMounting dimensions 500, 320, 250 and 160 GB models Hot-Plug compatibility Serial ATA Sata interfaceSerial ATA connector pin definitions Serial ATA device plug connector pin definitionsSignal Pin Function DefinitionCommand name Command code in hex Supported ATA commandsSupported ATA commands F3H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit WordShall be cleared to Set Features command values Set Features commandCode in features register A.R.T. command 3 S.M.A.R.T. commandsM.A.R.T. commands Technical Support Seagate Technology support servicesPresales Support Data Recovery Services Call Center Toll-free Direct dial Warranty ServiceData Recovery Services Authorized Service Centers Index ITE Page Barracuda 7200.12 Serial ATA Product Manual, Rev. B Page Seagate Technology LLC