Seagate ST3500830ACE, ST3250820ACE, ST3320820ACE, ST3300820ACE Configuring and mounting the drive

Page 29

3.0Configuring and mounting the drive

This section contains the specifications and instructions for configuring and mounting the drive.

3.1Handling and static discharge precautions

After unpacking, and before installation, the drive may be exposed to potential handling and electrostatic dis- charge (ESD) hazards. Observe the following standard handling and static-discharge precautions:

Caution:

•Before handling the drive, put on a grounded wrist strap, or ground yourself frequently by touching the metal chassis of a computer that is plugged into a grounded outlet. Wear a grounded wrist strap throughout the entire installation procedure.

•Handle the drive by its edges or frame only.

•The drive is extremely fragile—handle it with care. Do not press down on the drive top cover.

•Always rest the drive on a padded, antistatic surface until you mount it in the computer.

•Do not touch the connector pins or the printed circuit board.

•Do not remove the factory-installed labels from the drive or cover them with additional labels. Removal voids the warranty. Some factory-installed labels contain information needed to service the drive. Other labels are used to seal out dirt and contamination.

DB35.3 Series PATA Product Manual, Rev. C

21

Image 29

Contents DB35.3 Series Pata Page DB35.3 Series Pata Page Contents DB35.3 Series Pata Product Manual, Rev. C List of Figures DB35.3 Series Pata Product Manual, Rev. C Introduction DB35.3 Series Pata Product Manual, Rev. C Specification summary table Drive specificationsDrive specification ST3750840ACE ST3500830ACE ST3400820ACE DB35.3 Series Pata Product Manual, Rev. C Drive specification ST3320820ACE ST3300820ACE ST3250820ACE DB35.3 Series Pata Product Manual, Rev. C LBA mode Default logical geometryFormatted capacity Cylinders Read/write heads Sectors per track 16,383Drive specification Physical characteristicsRecording and interface technology 750GB 500GB 400GB 320GB 300GB 250GBStart/stop times Power specificationsSeek time DC power requirements Standby modeConducted noise Typical current profileActive mode Power-management modesIdle mode Sleep modeEnvironmental specifications Operating shock ShockNonoperating shock Disc models 4 Disc modelsIdle CE seek profile AcousticsFluid Dynamic Bearing FDB motor acoustics Electromagnetic immunity Safety certificationReliability Agency certification Korean RRL Electromagnetic compatibility Australian C-Tick N176 FCC verificationEuropean Union Restriction of Hazardous Substances RoHS Environmental protectionCorrosive environment DB35.3 Series Pata Product Manual, Rev. C Handling and static discharge precautions Configuring and mounting the driveBreather filter hole location Breather filter hole precautionsMaster/slave configuration Jumper settingsDrive as master with a non-ATA-compatible slave Cable-select optionUltra ATA/100 cable Drive mountingMounting dimensions-top, side and end view DB35.3 Series Pata Product Manual, Rev. C Pins and supported ATA signals ATA interface signals and connector pinsCommand name Command code in hex Supported ATA commandsF4H Word Description Value Identify Device commandXx07H Bit Word Description if bit is set to Bit Word0CH Set Features commandCode in features Register A.R.T. command 4 S.M.A.R.T. commandsInternet MySeagate Spp.seagate.com Warranty ServicePresales Support Technical SupportData Recovery Services Data Recovery Services Authorized Service CentersToll-free support numbers FAX services-All Europe toll callCall center Presales and Technical Support Warranty Service Asia/Pacific support services Index Page Page DB35.3 Series Pata Product Manual, Rev. C Page Seagate Technology LLC

Related manuals

Manual 48 pages 58.3 Kb