Philips FW-V795 manual Rear Connections, Power

VOLTAGE

SELECTOR

110V-

127V

220V-

240V

	Preparations
En					Television
glis
	AM loop
h	antenna
							FM wire
					L
					AUDIO		antenna
					OUT
					R
					VIDEO
					IN
					VIDEO OUT
					(CVBS) D
	speaker		E		B		speaker
	(right)		R	L			(left)
				AUX/
				CDRIN
				BOOSTER
				OUT	AM ANTENNA FM ANTENNA
			F	SUBWOOFER
				OUT	AC
					MAINS
				+	C
				R			A
				—		VOLTAGE
				—		SELECTOR
				L		110V-
						127V
				+		220V-
						240V
				SPEAKERS 6Ω
	booster				booster		AC power cord
	speaker				speaker
	(right)		POWER SWITCH		(left)
	BOOSTER IN
	R	L	OFF	ON			AC power cord
	SPEAKERS 6Ω		AC MAINS
	—	+
	R	R
	L	L
	—	+	VOLTAGE
			SELECTOR
			110V-	220V-
			127V	240V

Rear Connections

The type plate is located at the rear of the system.

APower

Before connecting the AC power cord to the wall outlet, ensure that the following are done;

– If your system is equipped with a

Voltage Selector, set the VOLTAGE SELECTOR to the local power line voltage.

– All other connections have been made.

WARNING!

–For optimal performance, use only the original power cable.

–Never make or change any connections with the power switched on.

To avoid overheating of the system, a safety circuit has been built in. Therefore, your system may switch to Standby mode automatically under extreme conditions. If this happens, let the system cool down before reusing it (not available for all versions).

8

pg 001-035/V795/21-Eng 8 4/16/02, 6:42 PM 3139 115 21281