Seagate ST340015ACE manual Ultra ATA/100 cable, Drive mounting, Master, Slave

Page 32

24	Barracuda 5400.1 Product Manual, Rev. G

3.3.3Ultra ATA/100 cable

An 80-conductor 40-pin cable is required to run Ultra DMA mode 3, mode 4 and mode 5. This cable uses even-numbered conductors connected to the ground pins to improve signal integrity.

	Note.
Master	Pin 1
	Pin 1
Slave	Computer
	Motherboard

If you are using a 40-pin 80-conductor cable, attach the blue connector to the motherboard, the black connector to the master drive, and the grey connector to the slave.

Figure 5. Ultra ATA cable connectors

Note. The drive supports both host and drive cable detection. The host detects the 80-conductor cable by sampling pin 34, CBLID–, on the interface bus. The drive detects the 80-conductor cable by sensing a capacitor at the host side through the CBLID– signal. The result is reported in a Fast Rise Detected bit (bit 13 of word 93 in the Identify drive parameter block).

3.4Drive mounting

You can mount the drive in any orientation using four screws in the side- mounting holes or four screws in the bottom-mounting holes. See Figure 6 for drive mounting dimensions. Follow these important mounting precautions when mounting the drive:

•Allow a minimum clearance of 0.030 inches (0.76 mm) around the entire perimeter of the drive for cooling.

•Use only 6-32 UNC mounting screws.

•Use only .045” +/- .005 high by .050” diameter bosses (4x) for bottom mounting applications to prevent deformation of the SeaShield.

•Do not overtighten the mounting screws (maximum torque: 6 inch-lb).

•Do not use a drive interface cable that is more than 18 inches long.

Image 32

Contents Page Page Page Page Contents Seagate Technology support services Barracuda 5400.1 Product Manual, Rev. GList of Figures Barracuda 5400.1 Product Manual, Rev. G Introduction Barracuda 5400.1 Product Manual, Rev. G Drive specifications Specification summary tableDrive specification ST340015ACE 50,000 Humidity SeaShield Physical organization Default logical geometryLBA mode Physical characteristics ATAPower specifications Seek timeStart/stop times Typical seek times msec Read WriteBarracuda 5400.1 Product Manual, Rev. G Power consumption Spinup powerSeek mode Read/write power and currentBarracuda 5400.1 Product Manual, Rev. G Typical 5V startup and operation current profile Power-management modes Active modeIdle mode Conducted noiseEnvironmental specifications Ambient temperature Sleep modeIdle and Standby timers Temperature gradient Wet bulb temperatureHumidity Relative humidity AltitudeBarracuda 5400.1 Product Manual, Rev. G Shock Operating shockNonoperating shock VibrationAcoustic mode AcousticsFluid Dynamic Bearing FDB motor acoustics Model Idle Quiet seek Performance seekReliability Performance Reference Test Description Level StandardKorean RRL Agency certification Safety certificationElectromagnetic compatibility FCC verification Barracuda 5400.1 Product Manual, Rev. G Configuring and mounting the drive Handling and static discharge precautionsBreather filter hole precautions Breather filter hole locationDrive as master with a non-ATA-compatible slave Cable select optionUltra ATA/100 cable Drive mountingMaster SlaveMounting dimensions-top, side and end view Barracuda 5400.1 Product Manual, Rev. G ATA interface signals and connector pins ATA interfaceO pins and supported ATA signals Command name Command code in hex ATA-standard commands EC HCommand name Command code in hex Identify Device command ATA-standard security commandsWord Description Value 0C5AHXxxxH Xx3FH Description if bit is set to Bit Set Features command 0CHF1H Report full capacity available 4 S.M.A.R.T. commands Code in features Register A.R.T. commandSeagate Technology support services Online Services Internet MySeagateAutomated Phone Services 40Barracuda 5400.1 Product Manual, Rev. GUSA/Canada/Latin America Support Services European Support Services Africa/Middle East Support ServicesAsia/Pacific Support Services Barracuda 5400.1 Product Manual, Rev. G Index GMR Barracuda 5400.1 Product Manual, Rev. G 48Barracuda 5400.1 Product Manual, Rev. G Page Seagate Technology LLC

Related manuals

Manual 2 pages 30.5 Kb