IPS-800/IPS-1600 Series - User’s Guide
➂Bus "A" Switched Plugs and Plug Indicators: AC Outlets that can be switched On, Off or rebooted in response to user commands.
•
•
•
•
➃Bus "B" Switched Plugs and Plug Indicators: AC Outlets that can be switched On, Off or rebooted in response to user commands. Includes same components listed in item 3 above.
➄Default Button: This button can be used to either reset the unit to default parameters or manually toggle all plugs On or Off:
•Default Parameters: With the Master I/O Switch (Master Power Switch) set in the Off position, press and hold the Default Button, then set the Master I/O Switch in the On position and release the Default Button. All menu defined parameters will be reset to default values.
•Manual Plug Toggle: Press the Default Button and hold it down for three seconds. All IPS power outlets will be toggled On or Off.
Note: If desired, the Default Button’s manual plug control capabilities can also be disabled as described in Section 5.3.1.
➅Unit Status Indicators: Two LED Indicators which function as follows:
•ON: Lights when power is applied to the IPS Unit.
•RDY: Flashes continuously when the IPS is ready to recieve commands.
➆Network Port and Activity Indicator: An RJ45 Ethernet Port for connection to your TCP/IP network. The default IP Address is 192.168.168.168, for more information, please refer to Section 5.3.4. The Activity Indicator flashes to indicate activity at the Network Port.
➇Master I/O Switch (Master Power Switch): Applies power to the IPS Unit. This switch must be "On" in order for the IPS to function. Note that this switch is not used to set the On/Off status of the switched outlets.
➈COM / RS232 Port: A DB9, RS232 serial port (DTE), for connection to a local terminal or external modem, as described in Section 4.3.