Western Telematic IPS-800-CE, IPS-1600 manual Web Server Parameters Menus

Page 37

Conﬁguration

Figure 5.14: Web Server Parameters Menu - Web Browser Interface

WEB SERVER:
1.	Service:	On
2.	Server Port #:	80

Enter Selection,

Press <ESC> to Exit ...

Figure 5.15: Web Server Parameters Menu - Text Interface

5.3.6.Web Server Parameters Menus

The Web Server Parameters Menus are used to conﬁgure the internal web server, which allows the unit to be operated via the Web Browser Interface.

•Web Browser Interface: Click the "Setup" button to access the conﬁguration menus, and then click the Web Server Parameters button. The Web Server Parameters Menu will be displayed as shown in Figure 5.14.

•Text Interface: Type /W and press [Enter]. The Web Server Parameters Menu will be displayed as shown in Figure 5.15.

The Web Server Parameters Menu allows you to deﬁne the following:

•Service: Enables/Disables the IPS’s Web Server. Note that when the Web Server is disabled, you will not be able to communicate via the Web Browser Interface. (Default = On.)

•Port Number: Sets the TCP/IP Port Number. The Port Number can be set to any valid number except 23; this is because 23 is the default port number that is used for communication with the unit via Telnet.

(Default = 80.)

5-19

Image 37

Contents Models User’s GuidePage Installation Instructions FCC Part 15 Regulation Table of Contents List of Figures Security Features and Co-Location Features Intelligent Power ControlEasy to Configure, Easy to Use IntroductionTypographic Conventions IPS-800, IPS-1600, IPS-800-CE and IPS-1600-CE UnitsIPS-800 Back Panel 120 VAC Model Shown Unit DescriptionIPS-800/IPS-1600 Series User’s Guide Apply Power to the IPS Hardware InstallationQuick Start Connect your PC to the IPS Communicating with the IPSPlug Status Screen Web Browser Interface IPS-800 Shown Text Interface Text Interface Type /X and press Enter IPS-800/IPS-1600 Series User’s Guide Power Supply Connection InstallationInstalling the Cable Keepers Connecting the Network Cable Connection to Switched OutletsConnecting a Local PC Connecting an External ModemSystem Mode and User Mode ConfigurationAccessing the Web Browser Interface Accessing the Text Interface $ telnet 192.168.168.168 Enter Configuration Menus General Parameters Menu Web Browser Interface General Parameters MenusGeneral Parameters Menu Text Interface IPS-800/IPS-1600 Series User’s Guide Serial Parameters Serial Parameters MenuIPS-800/IPS-1600 Series User’s Guide Plug Parameters Menu Web Browser Interface Plug Parameters MenusPlug Passwords and Co-Location Features Reboot Cycles Network Parameters Network Parameters MenusConﬁguration IP Security Feature Conﬁguration 12 Telnet Parameters Menu Web Browser Interface Telnet Parameters Menus14 Web Server Parameters Menu Web Browser Interface Web Server Parameters MenusSave Configuration Parameters Operation via the Web Browser Interface OperationPlug Status Screen Web Browser Interface Plug Status Menu Web Browser Interface IPS-800 Shown Plug Status Screen Text Interface Operation via the Text InterfaceOn 1 or /ON Router Boot/On/Off Commands Text InterfaceOFF 2 or /OF Router Applying Commands to Several Plugs Text InterfaceAutomated Mode Logging Out of Command ModeOperation Manual Operation Sending Parameters to a File Saving and Restoring Configuration ParametersRestoring Saved Parameters Upgrading the IPS Firmware IPS-800/IPS-1600 Series User’s Guide Serial COM / RS232 Port Interface Interface DescriptionApx-1 Apx-2 SpecificationsApx-3 Customer ServiceApx-4 Trademark and Copyright InformationIndex-1 IndexIndex-2 IPS-4 Internet Power Switch User’s GuidePage IPS-800/IPS-1600 Series User’s Guide Page Sterling Irvine California 949 586-9950 Toll Free