Western Telematic SRM-100 manual Download Parameters, Pass-Through Mode Console-Modem

Page 40

SRM-100 - Secure Rack Modem, User's Guide

Operation

7.6.7. Download Parameters

This function is used to save user-selected SRM parameters to an ASCII text file on your PC or control device. To save SRM parameters, please refer to the instructions in Section 8.1.

7.6.8. Pass-Through Mode (Console-Modem)

The Pass-Through Mode allows communication between the device connected to the Console Port and the SRM’s modem.

When the Pass-Through Mode is active, the Console Port can access the modem in order to place outbound calls, or to invoke modem AT commands. For a listing of available AT commands, please visit our User's Guide archive at http://www.wti.com/guides/guidarch.htm.

Note that when the Command Mode is accessed via modem, the Pass-Through Mode can also allow a remote user to access a control device connected to the Console Port.

To activate the Pass-Through Mode, proceed as follows:

1.Access the Command Mode as described in Section 5.1.

2.When the "SRM>" command prompt appears, type /U and press [Enter] . The Utilities Menu will appear as shown in Figure 7.2.

3.From the Utilities menu, type 8, then press [Enter] and follow the instructions in the submenu.

4.To exit from Pass-Through Mode and return to the Command Mode, type /X and press [Enter].

7-9

Image 40

Contents Users Guide Firmware Version 1.13 and HigherTable of Contents List of Figures OperationPassword Protected Access IntroductionFeatures Typographic ConventionsUnit Description Front PanelPower Switch Back PanelConnecting a PC to the Console Port Applying Power to the UnitGetting Started Communicating with the SRM-100 Commands Modem Port SettingsMT2834ZPX ATZSRM-100 Secure Rack Modem, Users Guide Hardware Installation Rack Mounting InstallationConnecting Power to the SRM-100 AC Powered UnitsDC Powered Units SetUp SwitchesDefault Modem Baud Rate Sw1, Sw2 Default Bits and Parity Sw4 Default Flow Control Format Sw3Default Rings to Answer Sw5 Default Modem Speaker Status Sw7 Default ARQ/Compression Status Sw6Default Security Mode Status Sw8 Initialize Unit to Default Settings Cable ConnectionModem Port Console PortTelco Line Command Mode Access Set-Up and ConfigurationAccess Via the Console Port Access via Modem General Parameters Menu General ParametersSuper ESCSet-Up and Configuration SRM-100 Secure Rack Modem, Users Guide Modem Parameters Modem Parameters MenuDTR SRM-100 Secure Rack Modem, Users Guide Save Parameters Password Directory Edit Password DirectoryAdd Name / Password EDIT/DELETE NAME/PASSWORD Edit / Delete from ListEdit / Delete from Search Viewing the Password Directory Password Directory Sample Data ShownZero Activity Counters Operation Password FunctionsSRM Operating Modes Console Port Password System PasswordUser Passwords Password on Dial Back Dial Back NumbersSuppressing the Confirmation Prompt Dialing Out from the Modem PortViewing the Audit Log Audit LogSRM-100 Secure Rack Modem, Users Guide Delete Entire Password Directory Utilities MenuZero All Activity Counters Delete Audit LogSend Test Message Default ParametersUpload Parameters Pass-Through Mode Console-Modem Download ParametersSaving and Restoring Parameters and Password Directory Sending Parameters to a FileRestoring Saved Parameters Console Port Interface DescriptionsModem Port Specifications CompatibilityCustomer Service Trademark and Copyright InformationIndex Index-1Index-2 Index-3