Western Telematic SRM-100 manual Restoring Saved Parameters

Page 42

SRM-100 - Secure Rack Modem, User's Guide

Saving and Restoring Parameters and Password Directory

8.2. Restoring Saved Parameters

Once menu selected parameters and the Password Directory have been saved, the parameters file can be uploaded to the SRM to quickly configure the unit without the need to manually enter each parameter and password. To restore saved parameters, proceed as follows:

Note: When the "Upload Parameters" function is performed via modem, the SRM will not immediately reset modem parameters. The unit will reset all other parameters, wait for the caller to disconnect, and then reset modem parameters.

1.Start your communications program and access the SRM Command Mode via the Console Port, or via modem using the System Password.

2.When the command prompt appears, type /U and press [Enter] .

a)The Utilities Menu will appear. From the Utilities Menu, type 6 and press [Enter]. The SRM will display a message which indicates that the unit is ready to receive the parameters file.

b)Set your communications program to upload an ASCII text file using the file name specified in Section 8.1. When the communications program is ready, begin the upload procedure.

3.The saved parameters file will be sent to the SRM-100, and the saved parameters and Password Directory will be restored. When the upload is complete, make certain to terminate your communication program’s upload mode.

8-2

Image 42

Contents Users Guide Firmware Version 1.13 and HigherTable of Contents List of Figures OperationPassword Protected Access IntroductionFeatures Typographic ConventionsUnit Description Front PanelPower Switch Back PanelApplying Power to the Unit Connecting a PC to the Console PortGetting Started Communicating with the SRM-100 MT2834ZPX CommandsModem Port Settings ATZSRM-100 Secure Rack Modem, Users Guide Connecting Power to the SRM-100 Hardware InstallationRack Mounting Installation AC Powered UnitsSetUp Switches DC Powered UnitsDefault Modem Baud Rate Sw1, Sw2 Default Flow Control Format Sw3 Default Bits and Parity Sw4Default Rings to Answer Sw5 Default ARQ/Compression Status Sw6 Default Modem Speaker Status Sw7Default Security Mode Status Sw8 Modem Port Initialize Unit to Default SettingsCable Connection Console PortTelco Line Set-Up and Configuration Command Mode AccessAccess Via the Console Port Access via Modem Super General Parameters MenuGeneral Parameters ESCSet-Up and Configuration SRM-100 Secure Rack Modem, Users Guide Modem Parameters Menu Modem ParametersDTR SRM-100 Secure Rack Modem, Users Guide Save Parameters Password Directory Edit Password DirectoryAdd Name / Password EDIT/DELETE NAME/PASSWORD Edit / Delete from ListEdit / Delete from Search Viewing the Password Directory Password Directory Sample Data ShownZero Activity Counters Password Functions OperationSRM Operating Modes System Password Console Port PasswordUser Passwords Password on Dial Back Dial Back NumbersSuppressing the Confirmation Prompt Dialing Out from the Modem PortViewing the Audit Log Audit LogSRM-100 Secure Rack Modem, Users Guide Zero All Activity Counters Delete Entire Password DirectoryUtilities Menu Delete Audit LogDefault Parameters Send Test MessageUpload Parameters Pass-Through Mode Console-Modem Download ParametersSaving and Restoring Parameters and Password Directory Sending Parameters to a FileRestoring Saved Parameters Interface Descriptions Console PortModem Port Specifications CompatibilityCustomer Service Trademark and Copyright InformationIndex Index-1Index-2 Index-3