Tyco Electronics 1529L manual Credit Card Reader, Barcode Scanner

Specifications
Sensor	SecuGen FOR
Image Capture Speed	600ms/frame
Image Transfer Speed	500Byte/ms
Pixel Resolution	356x292
USB Signaling Type	Full Speed Type

Theory of Operation

The USB host initiates communication with the FDU01 using operation commands (Sensor LED On, Fingerprint Capture Start and Stop). Fingerprint data are then cap- tured by the CMOS sensor at a total image size of 356 x 292 with 8-bit gray level. The image frame transfer speed is 500 bytes/ms. It takes about 600 milliseconds to send one frame of image data over USB protocols. FDU01 uses the SecuGen FOR (Fingerprint Optic Reader).

Sensor Specifications

Sensor	CMOS Image Sensor
Resolution	500dpi
Verifying Time	<1sec
Image Capture Error Rate	<0.1%
Life Time Typically	40,000Hrs

Credit Card Reader

There is a USB credit card reader only. The USB version is available in HID and Key- board emulation versions. The reader reads all three stripes on a standard credit card or drivers license.

Reference Standards-Conform to	International Standards Organization, American National Standards
applicable standards	Institute, California Drivers License, American Association of Motor
	Vehicle Administrators
Message Format	ACCII
Card Speed	3 to 50 IPS
MTBF Electronics	125,000 hrs; Head 1,000,000 passes

Barcode Scanner

Omni-directional scanner:

1.Ability to read 1D codes with a 360º rotation, eliminating the need to orient the scanner in the field of view

2.Scan angle

Minimum horizontal: 34º ± 1.5º

Minimum vertical: 12.5º ± 1.5º

3.Ability to read 2-D barcodes (PDF417, Micro PDF)

4.Ability to read damaged or poorly printed barcodes

1-4 Elo Touchmonitor User Guide