Tyan Computer TYAN S1471 user manual Integrated Peripherals

Page 34

4.9 Integrated Peripherals

Integrated Peripherals

Award Software, Inc.

IDE HDD Block Mode	:Enabled
IDE Primary Master PIO	:Auto
IDE Primary Slave PIO	:Auto
IDE Secondary Master PIO	:Auto
IDE Secondary Slave PIO	:Auto
On-Chip Primary PCI-IDE	:Enable
On-Chip Secondary PCI-IDE	:Enable
PCI Slot IDE 2nd Channel	:Enable
On-Board FDC Controller	:Enable
On-Board Serial Port 1	:Com1/3F8
On-Board Serial Port 2	:Com2/2F8
On-Board Parallel Port	:378/IRQ7
Parallel Port Mode	:Normal

The Settings in the Integrated Peripherals lets the user enable or disable on-board device. You can also configure the I/O and IRQ settings of the on-board serial and parallel ports.

S1471-001-01 http://www.tyan.com	34

Image 34

Contents Tyan S1471 Table Of Contents Introduction Hardware Specifications/Features Software Specifications EnvironmentBoard Installation On Board Resource Setting .1 S1471 Board Layout RTCCPU Speed Settings for Cyrix/SGS/IBM 6x86/M1 J15 J40 J39 CPU Voltage Regulator SettingsDefault CPU Multiplier J40 and J39 Volts J11 DefaultOff Memory Voltage DIMMs Default is Volts Host Bus Setting J15Keylock Connector J47 Reset Connector J41 Turbo LED Connector J48 Flash Eprom J50Cmos Resest/Password Reset J45Default off Infra Red Interface Con9 and Con10 Port Setting J13 and J14Speaker Connector J42 Turbo Switch J49 VCCTurbo Switch Speaker Connector InstallationTurbo LED Connector Installation Hardware Reset Switch Connector Installation Refer to for Flash Eprom upgrade procedures9DRAM Installation CPU Installation Peripheral Device Installation Upgrading Cache MemoryConnecting the Power Supply GND GND VCCPage To Enter Setup Before Boot Press CTRL-ALT- ESC or DEL KEY Entering SetupPress F1 to CONTINUE, CTRL-ALT-ESC or DEL to Enter Setup Control Keys Setup Page menu/Option Page Setup Menu Getting Help Main MenuChipset features setup Standard Cmos setupBios features setup Power Management setupDate Standard Cmos Setup MenuTime Primary/Secondary Drive type Drive a type/Drive B typeHalt On VideoEGA/VGA MemoryExpanded Memory Other MemoryVirus warning Boot SequenceSwap Floppy Drive Default value is Disabled CPU Internal Cache/External CacheBoot Up Floppy Seek Boot Up NumLock Status Default value is OnChipset Features Screen Chipset Features SetupVideo Bios Shadow Security OptionWPM Control by APM Power ManagementWVideo Off Method WStandby Mode Doze ModeWPower Down Activities PCI Slot Configuration Legacy ISA Resources Controlled ByWIRQ n assigned to PCI/ISA PnPIntegrated Peripherals Load Setup Defaults Enter PasswordROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC Password DisabledIDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Utility Screen Award Flash Memory WriterDMA Channels Timer MAPSystem Resource NMI