Tyan Computer TYAN S1471 user manual Flash Writer Utility

Page 38

5.0 Flash Writer Utility

Warning: Do not flash the BIOS unless instructed by your dealer.

You can upgrade the BIOS of your mainboard by using a "Flash Memory Writer"(FMW) utility. This utility can be downloaded from Tyan's BBS(Consult your system vendor for the phone #) or web site. The system BIOS is stored on a 'flash' EPROM ROM chip on the mainboard which can be erased and reprogrammed by the FMW. The following three files make up the FMW.

AWDFLASH.EXE

-The Flash Memory Writer utility for

 

Award to Award upgrade.

AMIFLASH.COM

-The Flash Memory Writer utility for

 

AMI to AMI upgrade.

README

-A text file of instructions

*S71AWXX.BIN

-XX-A 2-digit version number.

Flash memory writer records (or ‘programs’) a new BIOS onto the flash memory chip. You cannot upgrade an Award BIOS to a AMI BIOS or a AMI BIOS to an Award BIOS.

*This file name is subject to change and can have either a "bin" or a "rom" extention.

Note

You should ALWAYS clear your CMOS after flashing a BIOS. This will clear out any stray settings from your old BIOS which may have been carried over from the flashing process. Most problems encounterd after flashing a BIOS will be solved by this simple procedure.

S1471-001-01 http://www.tyan.com

38

 

 

 

 

 

 

 

 

 

Image 38
Contents Tyan S1471 Table Of Contents Introduction Hardware Specifications/Features Software Specifications EnvironmentBoard Installation On Board Resource Setting .1 S1471 Board Layout RTCCPU Speed Settings for Cyrix/SGS/IBM 6x86/M1 J15 J40 J39 CPU Voltage Regulator SettingsDefault CPU Multiplier J40 and J39 Volts J11 DefaultOff Memory Voltage DIMMs Default is Volts Host Bus Setting J15Cmos Resest/Password Reset J45Default off Reset Connector J41 Turbo LED Connector J48 Flash Eprom J50Keylock Connector J47 Infra Red Interface Con9 and Con10 Port Setting J13 and J14Speaker Connector J42 Turbo Switch J49 VCCTurbo LED Connector Installation Speaker Connector InstallationTurbo Switch Hardware Reset Switch Connector Installation Refer to for Flash Eprom upgrade procedures9DRAM Installation CPU Installation Peripheral Device Installation Upgrading Cache MemoryConnecting the Power Supply GND GND VCCPage Press F1 to CONTINUE, CTRL-ALT-ESC or DEL to Enter Setup Entering SetupTo Enter Setup Before Boot Press CTRL-ALT- ESC or DEL KEY Control Keys Setup Page menu/Option Page Setup Menu Getting Help Main MenuChipset features setup Standard Cmos setupBios features setup Power Management setupTime Standard Cmos Setup MenuDate Primary/Secondary Drive type Drive a type/Drive B typeHalt On VideoEGA/VGA MemoryExpanded Memory Other MemoryVirus warning Boot SequenceSwap Floppy Drive Default value is Disabled CPU Internal Cache/External CacheBoot Up Floppy Seek Boot Up NumLock Status Default value is OnChipset Features Screen Chipset Features SetupVideo Bios Shadow Security OptionWVideo Off Method Power ManagementWPM Control by APM WPower Down Activities Doze ModeWStandby Mode PCI Slot Configuration Legacy ISA Resources Controlled ByWIRQ n assigned to PCI/ISA PnPIntegrated Peripherals Load Setup Defaults Enter PasswordROM ISA Bios Cmos Setup Utility Award SOFTWARE, INC Password DisabledIDE HDD Auto Detection Flash Writer Utility Page Flash Memory Writer Utility Screen Award Flash Memory WriterDMA Channels Timer MAPSystem Resource NMI