(8)You should now be able to control the ML volume with both the device and the remote control. If you would like to use only one device to control audio volume, turn the volume to the highest settings on the device you do not want to use. This will give you full audio range. For instance, turning your computer volume to full will allow the MusicLites remote to control volume for the full capability of the MLs and your computer.
How do you connect the Universal Transmitter to a television or receiver?
(1)Make sure the house code is set to the proper code (default is 0). If not, take the screwdriver provided and turn to the correct house code.
(2)Decide what source you want it to play as. There is a sliding switch with 3 positions on the side of the transmitter. Slide it to S1, S2 or S3.
(3)Plug one end of the power adapter provided into the DC port of the Toslink and the other end into the wall outlet. The Universal transmitter will not work without power. The red indicator should light up to indicate that power is established. Then connect the optical cable into the Opt Port of the transmitter and connect to the television or receiver output. You will need to consult with your owner’s manual to make sure you are utilizing the correct port of the television or receiver.
(4)Make sure the MLs that you want to play are turned on (see ML
(5)There should be no need to check your output device since the connector of the Toslink plugged into your device will automatically divert the audio signal to the transmitter. If it does not check to make sure everything connection is tight.
(6)Pick something with audio to play and start it. The light on the transmitter should begin to blink between red and blue as it searches for synchronization with the MLs.
(7)When synchronization is made, the light will be blue. The MLs will also have a blue light that will light up momentarily as it receives the signal. The MLs should begin playing. You can use your device to set audio levels for the MLs. You should not need to adjust bass, treble, etc. and you will want to remove any existing EQ or tone settings. If synchronization is not made, you may need to check with your sources to make sure the MLs and the transmitter are set for the same source. Also, make sure your device is not set on mute. You may also want to check the MLs to make sure they were not inadvertently muted from the remote control.
(8)You should now be able to control the audio volume with both the device and the remote control. If you would like to use only one device to control audio volume, turn the volume to the highest settings on the device you do not want to use. This will give you full audio range. For instance, turning your computer volume to 100% will allow the MusicLites remote to control volume for the full capability of the MLs and your computer.
18