Transmitter for iPod/iPhone/iPad

(Part number 72469)

What comes with the transmitter?

•Transmitter for iPod/iPhone/iPad with rechargeable battery included

•AC adapter with cord and DC Output

• Remote control

• Easy Installation Guide

What does the Transmitter for iPod/iPhone/iPad do?

By plugging the Transmitter for iPod/iPhone/iPad into the 30-pin connector slot on your Apple device, you can play audio from that device and have it output to the MLs.

How does the Transmitter for iPod/iPhone/iPad work?

(1)Make sure the house code is set to the proper code (default is 0). If not, take the screwdriver provided and turn to the correct house code.

(2)Decide what source you want it to play. There is a sliding switch with 3 positions on the side of the transmitter. Slide it to S1, S2 or S3.

(3)Plug the Transmitter for iPod/iPhone/iTouch into your Apple device. If the device is turned on, a red light indicator on the top side of the transmitter will light up.

The Transmitter for iPod/iPhone/iTouch has a battery inside so you can operate with your Apple device

(4)unattached to a power adapter. It also comes with a wall adapter so you can be charging while operating the tandem devices. The charging will alternate between the Apple device and the transmitter until they are both at full battery power.

(5)Make sure the MLs that you want to play are turned on (see ML set-up section for details). Use the remote to make sure the MLs are looking to play from the source 1, 2 or 3 you picked (again, check the ML set-up section for how to do this).

(6)Pick something with audio to play and start it. The light on the transmitter should begin to blink between red and blue as it searches for synchronization with the MLs.

(7)When synchronization is made, the light will be blue. The MLs will also have a blue light that will light up momentarily as it receives the signal. The MLs should begin playing. You will not be able to use your Apple device settings to set audio levels for the MLs through use of the 30-Pin connector. It should not be neccessary to adjust bass, treble, etc., and you will want to remove any existing EQ or tone settings. If synchronization is not made, check your sources to make sure the MLs and the transmitter are set for the same source; your Apple device should not be set on mute. Be certain the MLs were not inadvertently muted from the remote control.