Sylvania ML-1 owner manual To avoid injury and/or property and product damage

Page 3

MPE Reminding

1.The installed antennas must not be located in a manner that allows exposure of the general population at a distance of less than 20cm.

2.Mount the antennas in a manner that prevents any personnel from entering the area within 20cm from the central position of the antenna.

To satisfy FCC RF exposure requirements, a separation distance of 20 cm or more should be maintained between this device and persons during device operation.

To ensure compliance, operations at closer than this distance is not recommended. The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter.

IMPORTANT SAFETY INSTRUCTIONS

READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS

BEFORE OPERATING THIS EQUIPMENT.

KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE.

WARNING

To avoid injury and/or property and product damage:

•Do not install this product anywhere it may be in direct contact with water or exposed to rain or moisture.

•Keep remote control, batteries, included scredriver and other small devices away from children.

•Do not use or install this product outdoors.

•Clean this product only with power disconnected and only with a clean, dry cloth.

•Only install this product in fixtures that can sturdily support weights of at least 1.5lbs (681 g).

•Use proper and safe bodily support when installing product in high locations.

•Use only in fixtures rated for the appropriate lamp wattage.

•Refer all servicing to qualified service personnel.

To avoid damage by possible fire:

•Do not block product’s ventilation openings.

•Do not install near heat sources such as radiators, heat registers, stoves or other heat-generating appliances.

CAUTION

•This product is not intended for use in emergency light fixtures or exit signs.

•Use only accessories specified by the manufacturer.

•To prevent early lamp failure, lamp should only be installed in operating environments ranging between -40 degrees Fahrenheit and +113 degrees Farenheit (-40 degrees Celcius and +45 degrees Celcius).

2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents MusicLites ML-1 and Accessories Receiver is To avoid damage by possible fire To avoid injury and/or property and product damageAbout Artison Trademark NoticeAbout MusicLites About Osram SylvaniaPage Table of Contents What are my options? What are they and why do we need them?House Codes How does the code get set?Zone Programming When do I set up the MusicLites as Left or Right? Audio Mode Set-UpWhy do I have to set up my speaker? How do I adjust the audio mode?How many sources can I have per zone? Setting Up the SourcesWhat is a source? How do the sources work?What does this mean for MusicLites? Understanding Wireless NetworksHow do I know when there is a problem? What should I do if I encounter the problem?How do I use zones to select source? Using the RemoteHow do I use zones to adjust light or volume? How do I replace the battery in my remote?How can I improve the range of my Transmitter? What is the range of my transmitter?What is the range of my remote control? RangeHow does the MusicLites module work? MusicLites ModulePart number What comes with the MusicLites module? What does the MusicLites module do?Page How does the USB Transmitter work? USB TransmitterPart number What comes with the transmitter? What does the USB Transmitter do?Transmitter for iPod/iPhone/iPad What does the Transmitter for iPod/iPhone/iPad do?How does the Transmitter for iPod/iPhone/iPad work? What does the Universal Transmitter do? Universal TransmitterPage Other Accessories Attribute Specification ETL
Top Page Image Contents