Perle Systems DS1, TS2 manual Default Disabled Hotkey Prefix, Data Range, Session Timeout

Serial Port Profiles

Enable Message of	Enables/disables the display of the message of the day.
the Day (MOTD)	Default: Disabled
Reset Terminal on	When enabled, resets the terminal definition connected to the serial port when
disconnect	a user logs out.
	Default: Disabled

Allow Port Locking When enabled, the user can lock his terminal with a password using the Hotkey Prefix (default Ctrl-a) ^a l (lowercase L). The IOLAN prompts the user for a password and a confirmation.

Default: Disabled

Hotkey Prefix	The prefix that a user types to lock a serial port or redraw the Menu.
	Data Range:
	z ^a l—(Lowercase L) Locks the serial port until the user unlocks it. The
	user is prompted for a password (any password, excluding spaces) and
	locks the serial port. Next, the user must retype the password to unlock the
	serial port.
	z ^r—When you switch from a session back to the Menu, the screen may
	not be redrawn correctly. If this happens, use this command to redraw it
	properly. This is always Ctrl R, regardless of the Hotkey Prefix.
	You can use the Hotkey Prefix key to lock a serial port only when the Allow
	Port Locking parameter is enabled.
	Default: Hex 01 (Ctrl-a, ^a)
Idle Timeout	Use this timer to close a connection because of inactivity. When the Idle
	Timeout expires, the IOLAN will end the connection.
	Default: 0 seconds so the port will never timeout
	Range: 0-4294967 seconds (about 49 days)
Session Timeout	Use this timer to forcibly close the session/connection when the Session
	Timeout expires.
	Default: 0 seconds so the port will never timeout
	Range: 0-4294967 seconds (about 49 days)
Session Strings	Controls the sending of ASCII strings to serial devices at session start as
	follows;
	z Send at Start—If configured, this string will be sent to the serial device
	on power-up of the IOLAN or when a kill line command is issued on this
	serial port. If the "monitor DSR" or "monitor DCD" options are set, the
	string will also be sent when the monitored signal is raised.
	Range: 0-127 alpha-numeric characters
	Range: Hexadecimal 0-FF
	z Delay after Send—If configured, will inset a delay after the string is sent
	to the device. This delay can be used to provide the serial device with time
	to process the string before the session is initiated or terminated.
	Default: 10 ms
Dial Timeout	The number of seconds the IOLAN will wait to establish a connection to a
	remote modem.
	Range: 1-99
	Default: 45 seconds

93