Perle Systems S-1110-XT manual Powering up the Perle Media Converter

Page 11

1.Attach the grounding lug to the ground wire.

2.Attach the lug to the chassis with the grounding screw(s).

Powering up the Perle Media

Converter

Extended Temperature models are supplied with a Pluggable Terminal Block

∙Unplug the terminal block from the Media Converter.

∙Ensure the Power Source is off.

∙Strip both wires 5mm (3/16th inch)

∙Loosen the terminal block screws and connect Positive (+) wire to the left terminal. Connect the Negative (-) wire to the right terminal. Tighten Terminal screws (0.22Nm- 0.25Nm torque).

∙Plug the terminal block into the Media Converter

∙Turn on power source.

∙Check that the PWR LED light is lit.

∙For extra power cable strain relief, attach the strain clip to the case as shown below, and thread the power cable through the clip in either one or two loops.

Perle 10/100/1000 Ethernet Extended Temperature Media Converter

11

Installation Guide

 

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Installation Guide 1110-XT Overview Model Connector Wavelength DistanceAuto-MDIX Jumper Settings InstallationSwitch Position Copper DIP SwitchesDIP Switch Settings Auto Negotiation copper SwitchSwitch Position Mode Link Mode SwitchSwitch Position Fiber Port Fiber Fault Alert SwitchIllustration of the FFA Duplex copper SwitchSwitch Position Copper port Switch Fiber Position Mbps Up default Auto Down Off Speed copper SwitchAuto Fiber Negotiation Switch Full/Half Duplex on Fiber SwitchInstalling the SFP Fiber Module Installing the Duplex Fiber CableLoopback Fiber-1 Switch Grounding the Media Converter Installing the Simplex Fiber CableInstalling the Copper Cable Powering up the Perle Media Converter LED Pattern OperationStatus LED No connectivity Troubleshooting GeneralMtbf SFP Models Technical SpecificationsMtbf SC/ST Models Budget Fiber Optic SpecificationsContacting Technical Support Copyright Warranty / RegistrationEN 55024, Class a Laser Safety IEC Compliance Information
Top Page Image Contents