Perle Systems S-1110-XT manual Installing the Duplex Fiber Cable, Loopback Fiber-1 Switch

Page 9

Half Duplex: The Media Converter Module will be set to Half Duplex mode on its fiber link.

Loopback Fiber-1 (Switch 7)

Switch Position

Mode

 

 

Up (default)

Disabled

 

 

Down

Enabled

 

 

Disabled: The loopback feature is disabled. This is default position for normal operation. The switch must be set to this position in order for data to pass through the media converter.

Enabled: This is a test mode. All data received on the receive (RX) fiber connection is looped back to the transmit (TX) fiber connection. The data link will be disabled; however power to the powered devices will be maintained. This mode will override all other switch settings.

Installing the SFP Fiber Module

SFP models only.

1.Locate the appropriate fiber module and insert the SFP into the opening on the front of the media converter.

2.Ensure the SFP module is properly seated. The release latch of the SPF fiber transceiver must be in the closed (up) position before insertion.

3.The SFP module may be inserted before or after applying power to the media converter.

4.Proceed with cable connections.

Installing the Duplex Fiber Cable

1.Locate a 1000Base-X compliant duplex (2 strands) fiber cable with appropriate connectors.

2.Connect the fiber cables from one media converter to the other media converter/switch/fiber device ensuring that the RX and TX are reversed (crossed) at the opposite end.

Perle 10/100/1000 Ethernet Extended Temperature Media Converter

9

Installation Guide

 

Image 9
Contents Installation Guide 1110-XT Overview Model Connector Wavelength DistanceAuto-MDIX Jumper Settings InstallationDIP Switch Settings DIP SwitchesAuto Negotiation copper Switch Switch Position CopperSwitch Position Mode Link Mode SwitchSwitch Position Fiber Port Fiber Fault Alert SwitchDuplex copper Switch Switch Position Copper portIllustration of the FFA Auto Fiber Negotiation Switch Speed copper SwitchFull/Half Duplex on Fiber Switch Switch Fiber Position Mbps Up default Auto Down OffInstalling the Duplex Fiber Cable Loopback Fiber-1 SwitchInstalling the SFP Fiber Module Installing the Simplex Fiber Cable Installing the Copper CableGrounding the Media Converter Powering up the Perle Media Converter Operation Status LEDLED Pattern No connectivity Troubleshooting GeneralTechnical Specifications Mtbf SC/ST ModelsMtbf SFP Models Budget Fiber Optic SpecificationsEN 55024, Class a Laser Safety IEC Warranty / RegistrationCompliance Information Contacting Technical Support Copyright