Perle Systems S-1110-XT manual Installation, Auto-MDIX Jumper Settings

Page 3

Installation

The default DIP switch settings (all switches in the UP position) will work for most installations.

These are the steps required to configure the Perle S-1110-XT Ethernet media converter:

1.Insert SFP Module (SFP Model only).

2.Set the Auto-MDIX jumper setting (optional).

3.Set the DIP switch settings (if required).

4.Set the Powering Option Jumpers (if required).

5.Install and connect the fiber cable(s).

6.Install and connect the copper cable(s).

7.Power up the media converter.

Auto-MDIX Jumper Settings

Note: The factory settings for Auto-MDIX will work for most installations, but in the rare case that you need to modify the settings, the procedure is below.

To access the Auto-MDIX jumper settings, unscrew the six side screws on the case and remove the cover plate. Locate the MDIX AUTO jumper set as detailed below. By covering or strapping pins 1 and 2, the S-1110-XT will operate as an MDIX device. By covering or strapping pins 2 and 3, the S-1110XT will automatically detect the Ethernet cable’s polarity. Removing the strapping is the same as AUTO.

Note: The default jumper setting is AUTO

Perle 10/100/1000 Ethernet Extended Temperature Media Converter

3

Installation Guide

 

Image 3
Contents Installation Guide 1110-XT Overview Model Connector Wavelength DistanceAuto-MDIX Jumper Settings InstallationSwitch Position Copper DIP SwitchesDIP Switch Settings Auto Negotiation copper SwitchSwitch Position Mode Link Mode SwitchSwitch Position Fiber Port Fiber Fault Alert SwitchDuplex copper Switch Switch Position Copper portIllustration of the FFA Switch Fiber Position Mbps Up default Auto Down Off Speed copper SwitchAuto Fiber Negotiation Switch Full/Half Duplex on Fiber SwitchInstalling the Duplex Fiber Cable Loopback Fiber-1 SwitchInstalling the SFP Fiber Module Installing the Simplex Fiber Cable Installing the Copper CableGrounding the Media Converter Powering up the Perle Media Converter Operation Status LEDLED Pattern No connectivity Troubleshooting GeneralTechnical Specifications Mtbf SC/ST ModelsMtbf SFP Models Budget Fiber Optic SpecificationsContacting Technical Support Copyright Warranty / RegistrationEN 55024, Class a Laser Safety IEC Compliance Information