MOUNTING
3.70” (94mm)
0.15” dia. (3.81mm)
4.05” (102.87mm)
Figure - 4. Panel Cutout and mounting hole dimensions
1.Cut out Panel and mounting hole dimensions as shown in the figure 8.
2.Remove the nuts from the mounting screws on the Panel Meter.
3.Insert panel meter into the hole until it is flush with the panel.
4.Install the nuts and tighten them till the unit is held firmly against the panel.
1. Remove nuts and insert Panel Meter & screws in mounting holes in panel cutout
2.Tighten the nuts, after mounting the unit in the panel cut out, till the unit is held firmly against the panel.
1.77”
(45mm)
Page 24