Omega Engineering DP3600 user manual SET UP Flow Chart

SET UP FLOW CHART:

			SETUP
	SCALING		PROGRAM LIMITS				PROGRAM SYSTEM
	(SCALING)		(PROG Lt)				(PrG SYS)
	HIGH SCALE		PROGRAM PROCESS LIMIT 1				DISPLAY OPTION
	(HI SCLE)		(PrG Lt1	--	01.234)		(dSP Opt)
						1.	PrOCESS
	LOW SCALE		PROGRAM PROCESS LIMIT 2			2.	SP dEn
	(LO SCLE)		(PrG Lt2	--	01.234)	3.	RAtE
			LIMIT 3 RATE OR PROCESS			4.	Pr CnG
	OFFSET					5.	HIGH Pt
	(OFFSET)		(Lt3 rtE) or (Lt3 Pr)			6.	LO Pt
		TARE	PROGRAM LIMIT 3 VALUE			7.	ELPSd t
						8.	SCAn
			(PrG Lt3	--	02.123)
	(TARE)
			LIMIT4 PROCESS / DEVIATION				FLASH TIME
			(Lt3 dEN) or (Lt3 Pr)			(FLASH t -- 00015)
			PROGRAM LIMIT 4 VALUE				ENGINEERING UNITS
			(PrG Lt4	--	01.123)		(EG UNIT -- PSI)
			TIMER 1 LIMIT				PROGRAM SETPOINT
			(tr 1 Lt	--	00012)		(SetPt	-- 1.234)
LT3 NORMALLY OPEN/CLOSE			TIMER 2 LIMIT				REMOTE TARE/HOLD
			(tr 2 Lt	--	00012)	(rt tArE -- rt HOLD)
(Lt3 n.O.	or	Lt3 n.C.)
LT4 NORMALLY OPEN/CLOSE			DEAD-BAND FOR LIMITS				INPUT TYPE
							(IP tYPE)
(Lt4 n.O.	or	Lt4 n.C.)	(dEAdbd	-- db 00012)
						1.	CurrEnt
						2.	VOLtAGE
LATCH OR NON-LATCH MODE			LT1 NORMALLY OPEN/CLOSE			3.	LO VOLT
(LATCH	--	nOn LCH)	(Lt1 n.O.	or	Lt1 n.C.)
							INPUT RANGE
AUDIO ALARM ON/OFF			LT2 NORMALLY OPEN/CLOSE				(IP rnGE – 020.00)
(ALr On	-- Alr OFF)		(Lt2 n.O.	or	Lt2 n.C.)
				10