NETGEAR TA612V manual Using the Router as a Dhcp server

Reference Manual for the Broadband Voice Adapter TA612V

•IP Address

This is the LAN IP address of the router.

•IP Subnet Mask

This is the LAN Subnet Mask of the router. Combined with the IP address, the IP Subnet Mask allows a device to know which other addresses are local to it, and which must be reached through a gateway or router.

•RIP Direction

RIP (Router Information Protocol) allows a router to exchange routing information with other routers. The RIP Direction selection controls how the router sends and receives RIP packets. Both is the default.

—When set to Both or Out Only, the router will broadcast its routing table periodically.

—When set to Both or In Only, it will incorporate the RIP information that it receives.

—When set to None, it will not send any RIP packets and will ignore any RIP packets received.

•RIP Version

This controls the format and the broadcasting method of the RIP packets that the router sends. (It recognizes both formats when receiving.) By default, this is set for RIP-1.

—RIP-1 is universally supported. RIP-1 is probably adequate for most networks, unless you have an unusual network setup.

—RIP-2 carries more information. RIP-2B uses subnet broadcasting.

Note: If you change the LAN IP address of the router while connected through the browser, you will be disconnected. You may need to restart your computer for the new IP address setting to take effect.

Using the Router as a DHCP server

By default, the router will function as a DHCP (Dynamic Host Configuration Protocol) server, allowing it to assign IP, DNS server, and default gateway addresses to all computers connected to the router's LAN. The assigned default gateway address is the LAN address of the router. IP addresses will be assigned to the attached computers from a pool of addresses specified in this menu. Each pool address is tested before it is assigned to avoid duplicate addresses on the LAN.

6-10 Advanced Configuration

202-10037-01, March 2005