NETGEAR HA311 manual Click OK when you are done

Page 27

This chart describes the information shown in the Status section of the dialog box:

 

STATUS

 

DESCRIPTION

 

 

 

Connect to

Displays the association of the access point or other wireless node in ad-hoc

 

 

mode.

 

AP MAC

Shows the MAC address of the associated access point when the HA311

 

Address

Wireless PCI Adapter is configured in infrastructure mode.

 

Network Mode

Indicates the configuration mode used -- 802.11a ad-hoc mode, ad-hoc mode,

 

 

or infrastructure mode.

 

 

802.11a ad-hoc mode: the wireless nodes form their own local network

 

 

 

where the end nodes communicate peer-to-peer without an access point.

 

 

Ad-hoc mode: offers higher data throughput than 802.11a ad-hoc mode, but

 

 

 

does not use beaconing or authentication.

 

 

Infrastructure mode: the wireless node searches all available wireless

 

 

 

channels to associate with an access point. The default value for Network

 

 

 

mode is Infrastructure.

 

Channel/

Shows the current channel and frequency in use. The wireless channel in use

 

Frequency

will be between 36 and 64.

 

Transmit Rate

Shows the current maximum transmit data rate of the wireless node. The

 

 

possible data rates supported are: 54 Mbps, 48 Mbps, 36 Mbps, 24 Mbps, 18

 

 

Mbps, 12 Mbps, 9 Mbps, and 6 Mbps. It can go up to 72 Mbps if the turbo

 

 

mode is enabled.

 

Receive Rate

Shows the current receive data transfer rate of the wireless node.

 

 

 

 

Encryption

Indicates if the WEP encryption is enabled or disabled.

 

 

 

 

Signal

Displays the signal strength of the radio frequency signal received by the

 

Strength

wireless node.

3.Click OK when you are done.

Congratulations, you have successfully installed NETGEAR’s HA311 Wireless PCI Adapter!

27

Image 27
Contents Netgear NETGEAR, INC Contents Introduction Benefits FeaturesSystem Requirements Package ContentsRelated Netgear Ieee 802.11a Products About This GuideGet Started Now Install the HA311 Utility Software InstallationPage Page Page Page Page Install the HA311 Wireless PCI Adapter Hardware InstallationHardware Description Page Page For Windows XP, 2000, ME, and 98 SE Users Install the HA311 Wireless PCI Adapter DriverClick Finish to close the Found New Hardware Wizard Verifying Driver Installation Page For Windows NT 4.0 Users Verifying NT 4.0 Driver Installation Windows XP Users Configure the HA311 Network SettingsAbout the HA311 Systray Application Icon Ad-hoc mode Infrastructure mode ColorConfiguring the HA311 Wireless PCI Adapter, on Test the Network Connection Status Click OK when you are done Status Section Configuring the HA311 802.11A Wireless PCI AdapterConfiguration Section Ssid Statistics Section About Section Wireless Network Fundamentals Wireless Network ConfigurationAD-HOC Mode PEER-TO-PEER Workgroup Infrastructure Mode Service Set Identification Ssid Authentication and WEP Encryption Wireless Channel Selection Ieee 802.11a Channel Allocations HE102 user can use eight channels in non-turbo mode Adapter Appendix A-TROUBLESHOOTINGModel HA311 802.11a Wireless PCI Adapter Appendix B-GENERAL SpecificationsTrademarks Appendix C-REGULATORY CompliancePage Radio Frequency Interference Requirements