NETGEAR HA311 manual Test the Network Connection Status

Page 26

Step 5—Test the Network Connection Status

Follow these steps to verify that the HA311 Wireless PCI Adapter has been successfully installed and that your wireless access is functioning properly.

1.Start the NETGEAR HA311 802.11a Configuration Utility and click the Status tab.

2.The Status section of the HA311 Configuration Utility dialog box will display the current condition of the wireless LAN.

26

Image 26

Contents Netgear NETGEAR, INC Contents Introduction Features BenefitsPackage Contents System RequirementsGet Started Now Related Netgear Ieee 802.11a ProductsAbout This Guide Installation Install the HA311 Utility SoftwarePage Page Page Page Page Hardware Description Install the HA311 Wireless PCI AdapterHardware Installation Page Page Install the HA311 Wireless PCI Adapter Driver For Windows XP, 2000, ME, and 98 SE UsersClick Finish to close the Found New Hardware Wizard Verifying Driver Installation Page For Windows NT 4.0 Users Verifying NT 4.0 Driver Installation Configure the HA311 Network Settings Windows XP UsersIcon Ad-hoc mode Infrastructure mode Color About the HA311 Systray ApplicationConfiguring the HA311 Wireless PCI Adapter, on Test the Network Connection Status Click OK when you are done Configuring the HA311 802.11A Wireless PCI Adapter Status SectionConfiguration Section Ssid Statistics Section About Section AD-HOC Mode PEER-TO-PEER Workgroup Wireless Network FundamentalsWireless Network Configuration Infrastructure Mode Service Set Identification Ssid Authentication and WEP Encryption Wireless Channel Selection Ieee 802.11a Channel Allocations HE102 user can use eight channels in non-turbo mode Appendix A-TROUBLESHOOTING AdapterAppendix B-GENERAL Specifications Model HA311 802.11a Wireless PCI AdapterAppendix C-REGULATORY Compliance TrademarksPage Radio Frequency Interference Requirements