NETGEAR HA311 manual

Page 9

Double-click the CD-ROM drive letter (such as D:\) to look at the contents of the CD-ROM.

3.Double-click the SETUP application icon to start the installation procedure. The InstallShield Wizard will open and display the NETGEAR HA311 Setup window, as shown here.

4.Click Next to continue.

Image 9

Contents Netgear NETGEAR, INC Contents Introduction Benefits FeaturesSystem Requirements Package ContentsRelated Netgear Ieee 802.11a Products About This GuideGet Started Now Install the HA311 Utility Software InstallationPage Page Page Page Page Install the HA311 Wireless PCI Adapter Hardware InstallationHardware Description Page Page For Windows XP, 2000, ME, and 98 SE Users Install the HA311 Wireless PCI Adapter DriverClick Finish to close the Found New Hardware Wizard Verifying Driver Installation Page For Windows NT 4.0 Users Verifying NT 4.0 Driver Installation Windows XP Users Configure the HA311 Network SettingsAbout the HA311 Systray Application Icon Ad-hoc mode Infrastructure mode ColorConfiguring the HA311 Wireless PCI Adapter, on Test the Network Connection Status Click OK when you are done Status Section Configuring the HA311 802.11A Wireless PCI AdapterConfiguration Section Ssid Statistics Section About Section Wireless Network Fundamentals Wireless Network ConfigurationAD-HOC Mode PEER-TO-PEER Workgroup Infrastructure Mode Service Set Identification Ssid Authentication and WEP Encryption Wireless Channel Selection Ieee 802.11a Channel Allocations HE102 user can use eight channels in non-turbo mode Adapter Appendix A-TROUBLESHOOTINGModel HA311 802.11a Wireless PCI Adapter Appendix B-GENERAL SpecificationsTrademarks Appendix C-REGULATORY CompliancePage Radio Frequency Interference Requirements