![](/images/new-backgrounds/1202484/20248429x1.webp)
1.Connect the female end of the supplied AC power adapter cable to the power receptacle on the back of the switch.
2.Connect the
When you apply power, the Power LED on the switch’s front panel will be Yellow, as it conducts a Power On Self Test (POST). After the switch passes the POST, the Power LED will change to Green and the switch is functional and ready to pass data. If the POST failed, the Power LED will blink in yellow.
If the Power LED does not go on, check that the power cable is plugged in correctly and that the power source is good. If this does not resolve the problem, refer to Appendix B, Troubleshooting.
Step 5: Connecting Devices to the Switch
The following procedure describes how to connect devices to the switch’s network
Figure 3-2. Connecting Devices to the Switch
Connect each device to an
Step 6: Installing a SFP Module
The following procedure describes how to install a SFP Gigabit Ethernet module in the switch’s Gigabit module bays. The Standard SFP Module is sold separately from the FSM7352S. If you do not want to install a SFP module at this time, skip this procedure.
To install a SFP module:
1.Insert the SFP module into the SFP module bay. Press firmly to ensure the module seats into the connector.
Page 15 of 24