NETGEAR FSM7352S manual Configuration, Switch Integrity, Auto Negotiation

Page 23

Configuration

If problems occur after altering the network configuration, restore the original connections and determine the problem by implementing the new changes, one step at a time. Make sure that cable distances, repeater limits, and other physical aspects of the installation do not exceed the Ethernet limitations.

Switch Integrity

If required, verify the integrity of the switch by resetting the switch. To reset the switch, use the Tools> Reset command or remove AC power from the switch and then reapply AC power. If the problem continues, contact NETGEAR technical support. In North America, call 1-888-NETGEAR. If you are outside of North America, please refer to the support information card included with your product.

Auto Negotiation

The 10/100/1000 Mbps ports negotiate the correct duplex mode and speed if the device at the other end of the link supports auto negotiation. If the device does not support auto negotiation, the switch only determines the speed correctly and the duplex mode defaults to half-duplex.

The gigabit port on the Gigabit module negotiates speed, duplex mode, and flow control, provided that the attached device supports auto-negotiation.

Page 23 of 24

Page 22 Page 24
Image 23
Page 22 Page 24
Contents
Trademarks Internet/World Wide Web Contents Figures Overview IntroductionFeatures Shows the package contents for the Managed Switch Package ContentsCD ROM Verify that your package contains the following10/100/1000 Mbps RJ-45 Ports Physical DescriptionFront and Back Panels SFP module bay Label Description LED DescriptionsConsole Port Page Preparing the Site InstallationCharacteristics Requirements Installing the Switch on a Flat Surface Installing the SwitchChecking the Installation Applying AC PowerInstalling a SFP Module Connecting Devices to the SwitchInstalling a Gigabit Ethernet fiber Module into an FSM7352S System Information FSM7352S # network parms 192.168.1.100 255.255.255.0Connecting the stacking modules Switch Management Appendix a Technical SpecificationsLayer 2 Services Layer 3 ServicesInterface Power SupplyPhysical Dimensions Environmental SpecificationsSafety Table B-1. Troubleshooting Chart Symptom Cause Solution Appendix B TroubleshootingTroubleshooting Chart Additional Troubleshooting SuggestionsAuto Negotiation ConfigurationSwitch Integrity Appendix C Default Settings
Related manuals
Manual 24 pages 31.02 Kb