NETGEAR 7000 Series Managed Switch Administration Guide
config network parms ipaddress netmask gateway
IP Address Unique IP address for the switch. Each IP parameter is made up of four decimal numbers, ranging from 0 to 255. The default for all IP parameters is zeroes (0.0.0.0).
Subnet Subnet mask for the LAN.
gateway IP address of the default router, if the switch is a node outside the IP range of the LAN.
6.To enable these changes to be retained during a reset of the switch, type
7.To view the changes and verify
8.The switch is configured for
Configuring for Out-Of-Band Connectivity
To monitor and configure the switch using
The following hardware is required to use the console port:
•
•An
Perform the following tasks to connect a terminal to the switch console port using
1.Connect an
2.Configure the terminal emulation software as follows:
a.Select the appropriate serial port (serial port 1 or serial port 2) to connect to the console.
b.Set the data rate to 115,200 baud.
c.Set the data format to 8 data bits, 1 stop bit, and no parity.
d.Set the flow control to none.
Getting Started |
v1.1, May 2006