NetComm NP642 manual Connecting the Antenna, You have screwed it all the way to its end

Page 11

Connecting the Antenna

Before continuing with the Software Installation section, you will need to connect the antenna

1.The antenna has a retaining nut which must be screwed into the connector on the back of the card. Place the screw retaining nut over the antenna connection on the rear of the NB642 and turn it clockwise.

Bend

antenna to a 90o angle

Screw

retaining nut

clockwise

over the antenna connection

Note:

Do not over-tighten the attaching nut - but do make sure that

 

you have screwed it all the way to its end.

2. Adjust the antenna to a 90o angle.

Note:

Please note that you may have to rotate the complete antenna

 

assembly to do this and have the antenna pointing vertically.

NP642 IEEE 802.11g PCI Adapter

11

YML785 Rev1

 

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Static Electricity Contents Introduction Wireless Standards Wireless TerminologyWPA System Requirements Getting to Know Your NP642 Package ContentsPower PWR NP642 LED IndicatorsPCI Card Installation Instructions Hardware InstallationYou have screwed it all the way to its end Connecting the AntennaWindows 98se/ME/2000/XP Utility and Driver Installation Software InstallationIconDescription Link Information Using the Wireless UtilityFieldDescription II. Configuration Tx Rate Preamble III. Advanced NP642 Ieee 802.11g PCI Adapter Default Key Select one of the 4 keys to use Network Key IV. Site Survey FieldDescription About Ascii Appendix a GlossaryCSMA/CA BSSDsss CSMA/CDDhcp Essid ESSIeee HEXRTS PlcpPpdu PsduWEP TCP/IPCopyright Information Contact InformationCustomer Information Product Warranty Limitations of Warranty
Top Page Image Contents