NetComm NP642 manual III. Advanced

Page 19

III. Advanced

In the Advanced page you can conﬁgure advanced settings for the NP642 wireless PCI Card

FieldDescription

Encryption: There are four options available: Disable (WEP), Enable (WEP), WPA and WPA-PSK. The default setting is set to “Disable”. Enable and Disable refer to WEP data encryption feature. If Enable is selected, you will be required to select the Authentication mode from the drop down list. If WPA is selected, conﬁguration is enabled. Select the “conﬁguration” button.

You will then be prompted with the following pop up window.

NP642 IEEE 802.11g PCI Adapter	19
YML785 Rev1

Image 19

Contents Page Static Electricity Contents Introduction Wireless Standards Wireless TerminologyWPA System Requirements Getting to Know Your NP642 Package ContentsPower PWR NP642 LED IndicatorsPCI Card Installation Instructions Hardware InstallationYou have screwed it all the way to its end Connecting the AntennaWindows 98se/ME/2000/XP Utility and Driver Installation Software InstallationIconDescription Link Information Using the Wireless UtilityFieldDescription II. Configuration Tx Rate Preamble III. Advanced NP642 Ieee 802.11g PCI Adapter Default Key Select one of the 4 keys to use Network Key IV. Site Survey FieldDescription About Ascii Appendix a GlossaryCSMA/CA BSSDhcp CSMA/CDDsss Essid ESSIeee HEXRTS PlcpPpdu PsduWEP TCP/IPCopyright Information Contact InformationCustomer Information Product Warranty Limitations of Warranty