Overview Section
Factory Defaults
The following table lists the Factory Defaults of your NB1300 ADSL Modem:
Field | Setting Details |
LAN IP address: | 192.168.1.1 |
|
|
LAN Subnet Mask: | 255.255.255.0 |
|
|
DHCP Server: | Enabled |
|
|
User Name: | admin |
|
|
Password: | password |
|
|
Main Function: | Router (Bridge Disabled) |
|
|
WAN connection type: | PPPoE LLC |
|
|
VPI: | 8 |
|
|
VCI: | 35 |
Note: These defaults may change with firmware updates and factory changes, please consult the NetComm website to check for the latest defaults.
Resetting to factory defaults
If you forget your passwords, lock out HTTP or FTP access or simply can’t remember what IP address you have set the NB1300 on you will probably need to perform a factory defaults reset.
To perform a factory defaults reset you must have physical access to the unit then follow these steps;
1.Make sure the NB1300 is powered on and the RDY light is flashing.
2.Locate the Reset button hole on the back of the unit.
3.Gently press in and hold the button for 5 seconds with a suitably thin appliance (E.g. straightened paper clip) seconds after release the RDY light will turn off.
4.Watch the RDY light and wait for it to stabilise and start pulsing again (in approximately 1 minute.
Note: Do not switch off or press reset again until the NB1300 has completed its reset and the RDY light is flashing.
5. Your router should now be set to factory defaults (192.168.1.1, ‘admin’ & ‘password’)
www.netcomm.com.au | Rev. 1- YML672 |
Page 10 | NB1300_2 ADSL Modem |