Nvidia 754 specifications Power Management Setup

Page 44

BIOS

4-5 Power Management Setup

Choose the “POWER MANAGEMENT SETUP” in the CMOS SETUP UTILITY to display the following screen. This menu allows the user to modify the power management parameters and IRQ signals. In general, these parameters should not be changed unless it’s absolutely necessary.

Figure 6: Power Management

HDD Power Down

Powers down the hard disk drive after a preset period of system inactivity. Options: Disabled, 1min ~ 15min.

Soft-Off by PBTN

Use this to select your soft-off function. The default is Instant Off.

Instant Off: Turns off the system instantly.

Delay 4 Second : Turns off the system after a 4 second delay. If momentary press of button, the system will go into Suspend Mode. Press the power button again to make system back to work.

PwerOn After Pwr-Fail

This item enables your computer to automatically restart or return to its last operating status after power returns from a power failure.

Off: The system stays off after a power failure.

Former-Sts:The system returns to the state it was in just prior to the power failure.

Page 4-14

Image 44
Contents Manual Revision August 30 Disclaimer of Warranties Post Port Frequently Asked Questions Table of Contents Section RAID Configuration Left Blank Introduction Mainboard Features RAID function available on chipset S-ATA/S-ATA II ports Special Features Bios Features Magic Health System Block Diagram Introduction Specification Mainboard Specification ProcessorChipset Main MemoryAt Rear Panel AudioPeripheral Interfaces Front Panel Controller Onboard connector and pin-headerSpecial Features Form Factor Installation Mainboard LayoutStep Installation Easy Installation ProcedureCPU Installation Installation Installation Jumper Settings Memory Installation Installation System Memory Configuration Memory LayoutMemory configurations supported Installation VGA Card Installation Installation Installation Device Connectors Jcpufan / Jpwrfan / JsysfanPW1 CD-INAUX-IN EZ-Button RESET, PW-ON CUSB3/CUSB4/CUSB5 Six USB 2.0 portsCFP CIR Cspk Installation Power-On/Off Remote Simple ATX power ON/OFF controllerInstallation To enter the Setup Program Main MenuStandard Cmos Setup Standard Cmos SetupAdvanced Bios Features Bios Features SetupInit Display First Security Option Advanced Chipset Features Chipset Features SetupFor setting Dram command rate timing Options Auto, 1T, 2T Options Auto, 2.5ns to 9.5ns in 0.5ns increments Options Auto, 1ns ~ 15ns Integrated Peripherals Integrated PeripheralsChipset IDE Devices Onboard Device Legacy Devices Power Management Setup Power ManagementPNP/PCI/PCI-E Configuration PNP/PCI/PCI-E Configuration SetupPCI Express related items Interrupt requests are shared as shown belowPC Health Status PC Health StatusVoltage level of the 5V Standby Smart Fan example Power Bios Features Frequency/Voltage ControlPcie Clock Load Optimized Defaults Defaults MenuLoad Fail-Safe Defaults Enter Password Supervisor/User Password SettingExiting Bios Save & Exit SetupSave to Cmos and Exit Y/N? Y Exit Without SavingRAID Basics RAID ConfigurationIntroduction RAID 0 Striping RAID Configuration NVidia RAID Features RAID Configuration Enable RAID Function Enable RAID ROMRAID Configuration Create RAID Array Prepare driver floppyInstall O/S into RAID disk Install Software utility for WindowsDriver Installation Easy Driver InstallationDriver Installation Realtek Sound Manager Quick User-guide Sound EffectDriver Installation Equalizer Speaker ConfigurationDriver Installation Speaker Test Connector SensingDriver Installation Connector Sensing Driver Installation Hrtf Demo MicrophoneDriver Installation General Driver Installation Update Your System Bios AppendixKey in File Name to save previous Bios to file Nvidia RAID Bios Utility Using the Define a New Array WindowCompleting the RAID Bios Setup Appendix Appendix Appendix C Appendix Appendix If password is set, ask for password