Multi-Tech Systems FR2201 manual Shunts

Page 10

MultiFRAD II User Guide

Shunts

There are three shunts (Figure 1-3) on the printed circuit board for the trunk and the data channels.

Trunk RS232

Shunt Position

Trunk V.35

Shunt Position

Channel 1 V.35

Shunt Position

Channel 2 V.35

Shunt Position

Figure 1-3. Shunts

The MultiFRAD has separate shunts for the trunk and both data channels. Both the default RS232 Shunt Position and the V.35 position for the Trunk are identified. The V.35 positions for the Channel shunts are also shown. To change the position of a shunt, refer to the V.35 Shunt procedure in Chapter 2.

10

Image 10

Contents User Guide User Guide Contents Appendixes Introduction and Description Introduction MultiFRADPreview of this Guide Introduction and DescriptionFront Panel Description EthernetEthernet AUI Connector Back Panel DescriptionShunts ShuntsTechnical Specifications Data PortsMultiFRAD II User Guide Installation Unpacking your MultiFRAD UnpackingCabling Procedure Step Procedure Cabling your MultiFRADMultiFRAD II User Guide Software Loading and Configuration Installing your Software Choose Destination Location screen is displayedSoftware Loading and Configuration MultiFRAD II User Guide Software Loading and Configuration MultiFRAD II User Guide Software Loading and Configuration MultiFRAD II User Guide MultiFRAD Software Download User Defaults Before You BeginDownload Firmware MultiFRAD Configuration Setup MenuIP Setup MultiFRAD II User Guide IPX Setup MultiFRAD II User Guide Spanning Tree Setup Statistics IP Statistics IPX Port Statistics STP Spanning Tree Port StatisticsSnmp Statistics WAN Statistics Frame Relay StatisticsData Port Statistics WAN Port Setup Point to Point Setup Frame Relay Setup MultiFRAD Software MultiFRAD II User Guide MultiFRAD Software Data Port Configuration Remote Configuration and Management Modem-Based Remote Configuration Procedure Remote Configuration and Management MultiFRAD II User Guide Telnet MultiFRAD Management Remote User Database Web Browser Management Warranty, Service and Tech Support Limited Warranty On-line Warranty RegistrationRecording MultiFRAD Information Tech SupportContacting Tech Support via E-mail Service To log on to the Multi-Tech BBS Multi-Tech BBSTo Download a file About CompuServe About the Multi-Tech Fax-Back ServiceAbout the Internet Appendixes Appendix a Cabling Diagrams Command Port Cable LAN CablesTrunk Cable RS232C/V.24 * Link CableRemote Configuration Cable Command PortAppendix B Regulatory Information Appendix C Network Overview Figure B-1. OSI Protocol StackPacket Network Address Internet Protocol IPIP Addressing MultiFRAD II User Guide Glossary MultiFRAD II User Guide Glossary MultiFRAD II User Guide Glossary MultiFRAD II User Guide Glossary MultiFRAD II User Guide Glossary MultiFRAD II User Guide Subscriber Loop See Local loop MultiFRAD II User Guide Glossary About the Multi-TechFax-Back Service Recording MultiFRAD Information